Models > YISR309JTAAA

YISR309JTAAA General Electric Washer - Overview

Get Parts and Repair Help for YISR309JTAAA

If you know the washer repair part you need, you can browse the list of all parts on the YISR309JTAAA, or you can search by name or part description. You can also find your part by where it is located on the YISR309JTAAA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for YISR309JTAAA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.71

Tub Dampening Strap

Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.

$3.62

D-Shaped Knob Insert Clip

Sold individually.

$5.93

Agitator Coupling Kit

Washing machine agitator drive bell with bolt. It connects the transmission drive shaft to the agitator base. *NOTE: Hold down bolt not sold separately.

$7.32

Selector Knob with Clip

This white knob accepts a D-shaped shaft. Sold individually.

$9.94

Drain Hose Extension - 4 1/2' Long

$3.27

Timer Knob Clip

$3.00

Drain Hose Clip

This clip holds the drain hose to the back of the washer.

$5.89

V-Style Drive Belt

$37.23

Dual Action Agitator

This does not come with the fabric dispenser - must order separately or use original part.

$7.23

SEAL TUB

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

One of eight clips broke off of the agitator assy allowing the assembly to come lose on heavy loads.

  • Customer: Paul from Carneys Point NJ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 495 of 501 people found this instruction helpful
I replaced the coupling by only having to remove one bolt with a socket wrench. Once replaced I installed the new assy over the coupling making sure ro align the splines then pushing down until the assy snapped into place. Easy. read more

Replaced broken START knob on dryer.

  • Customer: SAM from ROCK HILL NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 466 of 469 people found this instruction helpful
Slid off the old START knob, then pushed on the new START knob.

I created and printed a label on my computer for use with the time selector dial, which must be set at or beyond 10 minutes, before turning the START knob.

I made a label that says "Minimum" with a red arrow that points past the 10 minute setting on the time selector dial.<... read more

The inside of the Selector Knob was stripped

  • Customer: Frank from Irvine CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 369 of 372 people found this instruction helpful
Removed the damaged knob and replaced it with the new knob. Very ease read more