YGH8155XJT0 Whirlpool Microwave - Instructions

I just opened the box and set it in. Took all of two minutes.

Easy, perfect

Very easy to change,I remove 3 sctrews and inside choke when out I put the 2 screws from handle and back to the same place ,finish . I read that it was very difficult but that is not

just replaced the filters

Removed microwave case and bad part was right there in plain sight attached to the magatron. Two screws and two wires and part replacement was done. Plugged in microwave and works perfect. Couldn't have been any easier. Thanks for the easy troubleshooting and parts suggestions on your site.

With a phillips head screwdriver I removed the screws, which were screwed to the then non-existent grille, at the top of the grille holder, GENTLY popped the new grill into place and replaced the screws. It took about five minutes. As a housewife, I feel that doing these little repair jobs around the house saves my husband time and aggravation. It was all very simple, and I got the ordered part in two days. Fabulous!

a lot of work to get in place properly without breaking the plastic inserts

replaced burnt parts

I had been dealing with a broken vent cover and burned out light for several months. I should have fixed it much sooner if I knew how easy it was. PartSelect.com had pictures of everything I needed and after reading the repair stories I was able to disassemble the pieces necessary and clean them before reinstalling. Very fast shipping also. The vent grille attaches easily with a couple screws. It's weakest point is the plastic tabs which will break and then gravity puts the grill in the doors ways. The light bulbs can be accessed with a hinged glass door (one screw) but be careful they are very fragil and can break off. If they do unplug your unit, get a pair of needle nose pliers and slowly unscrew the rest of the bulb. If you wanting room or you want to clean the grease off, I recommend removing the whole bottom cover from the microwave (7 scews and 2 wire harness clips).

The installation was very easy. But I was most amazed by how quickly the part arrived. I ordered it online late in the afternoon and it was delivered in the morning on the NEXT DAY!

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.

This repair was pretty simple. 1. I removed the three screws on the side of the door. 2. With the help of a flat head screwdriver, I pried off the exterior door panel. 3. I removed the glass from the broken panel by lightly tugging on one of the longer sides of the panel. The glass became free to easily pull out. 4. I washed the glass panel with lots of Dawn to get rid of all the grease buildup. 5. Using the same method for taking out the glass panel, I placed the clean glass into the new exterior panel. 6. I placed the handle under the door panel, and screwed it in. (If you are ordering new screws, make sure you order two, we bought 1 thinking we would get to, and fortunately we were able to salvage one of the old screws.) 7. Lastly, I snapped (with force) the door back onto the internal door panel and screwed the nails back in. Voila

Simply placed new dish on the rotating hub.

I didn't do the repair -- my husband did, said it was easy, had no problems what so ever! The new bulbs give a lot more light to the cooking area.

I called the repair/parts number to make sure I had correct parts and the young lady instructed me as to the size of the serving tray; within 48 hours we had the VERY carefully wrapped carton opened and back in the microwave, working perfectly. Thank you. We'll recommend you to our friends!