Models > YGBS307PDB8

YGBS307PDB8 Whirlpool Oven - Overview

Get Parts and Repair Help for YGBS307PDB8

If you know the oven repair part you need, you can browse the list of all parts on the YGBS307PDB8, or you can search by name or part description. You can also find your part by where it is located on the YGBS307PDB8 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for YGBS307PDB8 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$46.96

Inner Door Glass

$42.82

Bake Element

$36.04

Oven Rack

Sold individually.

$2.70

Screw

This screw is sold individually.

$5.25

Touch-Up Paint - White

$37.04

Thermal Overload Safety Thermostat

This part establishes and maintains the internal temperature of the oven cavity.

$23.36

Light Bulb - 120-130V - 15W

Sold individually.

$18.07

2 Piece Broiler Pan

$63.84

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$40.91

Broil Element

This broil element is found on the roof of the oven.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broke the glass panel inside the oven door -- dropped a baking dish on the glass!

  • Customer: Robert from Wildwood MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 66 of 89 people found this instruction helpful
Easily removed the door from the oven by releasing clips attached to the door hinge -- very nicely engineered. Removed about 6 philips head screws to allow the door assembly to be taken apart for access to the glass. Lifted out the broken glass, cleaned the inside of the door, installed the new glass, reassembled the door (a two minute project), and reatt... read more

No heat after cleaning oven

  • Customer: Frederick from St. Louis MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 44 of 50 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

Cracked the inner door glass by wiping with wet rag when hot

  • Customer: James from Renton WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 24 of 29 people found this instruction helpful
Removed the oven door by following the straightforward instructions in the user's manual. Removed philips head screws to take the door assembly apart. Removed clips holding the two inner door glass plates, and the two plates. Removed the clamp holding the broken glass plate, then the glass and associated glass fragments. Then cleaned and re-installed the... read more