Models > XRSS687BB

XRSS687BB (PXRSS687BB0) Amana Refrigerator - Overview

Get Parts and Repair Help for XRSS687BB

If you know the refrigerator repair part you need, you can browse the list of all parts on the XRSS687BB, or you can search by name or part description. You can also find your part by where it is located on the XRSS687BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for XRSS687BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$49.48

Ice and Water Filter

Sold Individually.

$2.70

Screw

This screw is sold individually.

$3.61

Door Closure Cam Kit

This part helps with the closing of the door and helps keep them in position.

$3.76

Crisper Frame Support

Note: If the wall anchor that this piece mounts on is broken, then the support is needed. (Order per Model#)

$52.91

Crisper Pan - Large

$12.84

Icemaker Helix End Cap

This cap is white in color and is made of plastic. This end cap is used in a refrigerator's icemaker.

$55.17

Ice Bucket

$2.70

Screw

This screw is sold individually.

$4.46

Toe Grille Clip

$127.20

Icemaker Auger and Crusher Blade Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Door would not close

  • Customer: Russ from Asheville NC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 35 of 38 people found this instruction helpful
After emptying the refrig. door, I unscrewed the plate on the top of the refrigerator that covered the door bolts. Then off with the three bolts. I removed the door by lifting it up a few inches. The two parts of the door cam were easily removed and replaced with the new part. BEFORE REPLACING the door spread vasoline on both cam parts.
(Not after as ... read more

Ice maker would not turn allowing the ice to come out the dispenser. The ice bucket was also cracked from kids (ok and parents) getting frustrated and shaking the ice bucket!

  • Customer: Todd from Lancaster PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 25 of 30 people found this instruction helpful
Piece of cake!

Removed the old ice bucket which was cracked and ice would not dispense. The Helix Cap also looked worn which is why I ordered both parts. (Probably if not for the shaking of the ice bucket the Helix cap would have been the only part required. We ended up cracking the ice bucket) Removed the four hex screws from the auger system on... read more

Ice Dispenser had jammed up and become inoperative

  • Customer: James from Robinson TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 21 of 24 people found this instruction helpful
The parts discription was a bit vague and I wasn't sure exactly what I was ordering, but I received everything I needed and it works fine. The combination screw conveyor/ice crusher came in one piece. The ice cube bin is a plastic assembly that snaps apart. I used a wide blade screw driver carefully to facilitate assembly/disassembly. Once you have it ap... read more