Quick Question!

Have you ever purchased from PartSelect.com before?

Models > X8241RA

X8241RA Maytag Cooktop - Overview

Get Parts and Repair Help for X8241RA

If you know the cooktop repair part you need, you can browse the list of all parts on the X8241RA, or you can search by name or part description. You can also find your part by where it is located on the X8241RA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the X8241RA

[Viewing 3 of 3]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$49.74

Burner Head Cap with Spark Electrode

This is a black burner head with the spark electrode. NOTE: This part has been updated and there is no longer a gasket seal required.

$5.15

Screw

This screw is sold individually.

$4.89

SCREW

Part might differ in appearance, but functions same as original. Sold individually.

$17.25

Top Burner Knob - black

This top burner knob is just over two inches in diameter. It is black in color and is made of plastic. This knob has white lettering denoting the off, low, light, and high positions. It also has a red indicator line and a line of decorative red flames of various sized denoting the temperature level. This knob will accept a 'D' shaped shaft.

$66.80

Burner Grate Kit

This kit includes 4 black burner grates.

$4.89

Igniter Wire

This igniter wire is twenty-eight inches long.

$2.78

Screw - 6-32 x 5/16

This screw is well under an inch long, and is made of metal.

$4.89

SCREW

Sold individually.

$33.16

Burner Switch

Order quantity required.

$58.31

Burner Grate

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner wouldn't start

  • Customer: Yury from Brooklyn, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 32 of 45 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

burner head was rusted out. ordered 1 to see if part was correct. ordered 4 more to finish job.

  • Customer: Robert from Somerville, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 13 of 17 people found this instruction helpful
unscrewed old burner head ;disconnected 2 wires; repaced with new burner head and replaced wires. Unfortunately, before we really needed to replace the other burner heads, the cooktop itself developed a gas leak. We decided to replace the whole thing, and therefore would like to return the unboxed, unused 4 remaining burner heads. read more

Burner Head Rusted Out

  • Customer: Edmundo from San Antonio, TX
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Slightly turn burner head clockwise and it comes out. Pulled out spark electrode wire and hand installed it into new piece. Cleaned area and replaced burner head with a slight twist to lock in place. Bought two and have spare one left. Other three burners are ok but slightly rusted. We are ready for the next one to show a leak. May just replace th... read more