Models > WWX645RBW1

WWX645RBW1 Frigidaire Washer - Overview

Get Parts and Repair Help for WWX645RBW1

If you know the washer repair part you need, you can browse the list of all parts on the WWX645RBW1, or you can search by name or part description. You can also find your part by where it is located on the WWX645RBW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WWX645RBW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$21.43

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$4.45

Leveling Leg

$36.93

Washer Lid Lock with External Safety Switch

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

$12.87

Tension Idler Pulley

This idler arm assembly comes with the pulley wheel.

$46.50

Tub Seal Assembly

This seal helps prevent any leaking around the transmission of washing machines.

$41.77

Spin Bearing

$7.04

Upper Spin Bearing Washer

$7.77

SPACER

This spacer goes between the timer knob and the dial.

$25.05

Tension Spring

This spring works in conjunction with the idler pulley.

$7.08

SPRING

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

washer leaking

  • Customer: Michael from Woodridge IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 34 of 41 people found this instruction helpful
removed front body panel (2 screws at bottom and pulled down panel), then used pliers to squeeze pinch clamps and pull back the two hoses off the pump. then removed the two pump clips that secure the pump in place and used screw driver to gently pry the old pump off the motor shaft, under that was the rubber pump slinger which was pulled off the motor shaft.... read more

Lid Lock Assembly broke

  • Customer: Jenessa from Tacoma WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 30 of 38 people found this instruction helpful
The Lid Lock Assembly came super fast! The install would have been flawless, but the "pre-drilled" holes on the new Lid Lock Assembly were way to small. We found that out after we had reconnected the wires and gotten it into place. Aside from that small set back, the install went great! This repair is definitey not one that you would need to pay a repair... read more

washer continued to fill to point of overflow

  • Customer: alvaro from east hampton NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 26 of 30 people found this instruction helpful
FIRST I REMOVED THE TOP PANEL HELD BY FOUR SCREWS AT REAR OF PANEL, PULLING THE PANEL FOWARD AND UP. THEN DISCONNECTED THE POWER AND WATER CONNECTIONS. THEN I REMOVED THE TWO SCREWS HOLDING THE FLOW VALVE TO THE WASHER REAR PANEL,PULLED THE VALVE FOWARD ,REMOVED THE TWO ELECTRIC CONNECTORS, PINCHED THE WATER CLAMP WITH PLIERS AND REMOVED THE WATER CONNECTI... read more