Models > WWS233RBW0

WWS233RBW0 Frigidaire Washer - Overview

Get Parts and Repair Help for WWS233RBW0

If you know the washer repair part you need, you can browse the list of all parts on the WWS233RBW0, or you can search by name or part description. You can also find your part by where it is located on the WWS233RBW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WWS233RBW0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$12.46

Drive V-Belt

This belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

$17.91

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$33.09

Washer Lid Lock with External Safety Switch

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

$5.27

SCREW

$9.60

Tension Idler Pulley

This idler arm assembly comes with the pulley wheel.

$4.45

Leveling Leg

$46.50

Tub Seal Assembly

This seal helps prevent any leaking around the transmission of washing machines.

$25.93

Agitator Drive Block

$7.43

CLAMP

$7.04

Upper Spin Bearing Washer

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The primary problem was that the tub seal assembly was leaking.

  • Customer: Rick from Walkerton IN
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Socket set
  • 154 of 188 people found this instruction helpful
1. I began by removing the two screws that hold the front panel in place. I then lifted the top free of the front panel and tilted it back to get it out of the way.

2. Using my fingers, I released the tabs that connect the tub cover to the tub. It took some effort to remove the cap("Mechanism") over the bolt connecting the agitator to the agitat... read more

replace broken drive belt

  • Customer: rodney from fairfield bay AR
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 129 of 146 people found this instruction helpful
carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run... read more

Lid Lock Assembly broke

  • Customer: Jenessa from Tacoma WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 38 of 47 people found this instruction helpful
The Lid Lock Assembly came super fast! The install would have been flawless, but the "pre-drilled" holes on the new Lid Lock Assembly were way to small. We found that out after we had reconnected the wires and gotten it into place. Aside from that small set back, the install went great! This repair is definitey not one that you would need to pay a repair... read more