Models > WWP1170FAW

WWP1170FAW General Electric Washer - Overview

Get Parts and Repair Help for WWP1170FAW

If you know the washer repair part you need, you can browse the list of all parts on the WWP1170FAW, or you can search by name or part description. You can also find your part by where it is located on the WWP1170FAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$7.33

Hose Clamp Kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

$10.25

V-Style Belt

This washing machine v-shaped belt is cloth covered.

$4.49

THRUST WASHR

$3.62

CLIP-PKG 12

$45.02

Industrial Sealant

Red 3M800

$3.41

FILT&WASHER

LINT FILTER

$46.98

KNOB-ROTARY

$79.66

SEAL ASM TUB

$6.84

SPRING WASHR

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

belt worn causing machine to make all kinds of noise

  • Customer: Kenneth from Baltimore MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 17 of 23 people found this instruction helpful
pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!! read more

drive belt replacement

  • Customer: Scott from Cumming GA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 2 of 3 people found this instruction helpful
removed rear panel, tilted machine forward, removed four bolts holding the pump and loosened the connection to the motor shaft,(several times dropped socket and without magnet to retrieve tools would have been much more difficult),removed two hoses, dropped pump assembly, replaced belt, and reversed the process to re-assemble. Easy to find part and will defi... read more

Worn out belt replacement

  • Customer: DAVID from WAPAKONETA OH
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
First unplug power cord and removed water hoses, then removed rear panel of machine. Shop-vac old debries out of machine Remove small spring holding belt tensioner pulley assembly. Remove hex key from motor shaft that connects to the pump. Use pliers to spin clamps out of way so you can then remove the (4) four bolts that hold pump to bottom of the motor, no... read more