Models > WWGF3004KWE

WWGF3004KWE Westinghouse Range - Overview

Get Parts and Repair Help for WWGF3004KWE

If you know the range repair part you need, you can browse the list of all parts on the WWGF3004KWE, or you can search by name or part description. You can also find your part by where it is located on the WWGF3004KWE by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the WWGF3004KWE [Viewing 6 of 6]

$25.73

Natural Gas to Liquid Propane Conversion Kit

$8.08

ANTI TIP KIT

$28.21

Oven Probe

$18.75

Light Bulb Lens

This lens covers the interior oven light bulb.

$7.04

Rear Drawer Glide

Sold Individually.

$4.23

Steel Washer

Size: 3/4 inch od x 1/4 inch id

$7.04

Front Drawer Glide

$7.09

Foot Leveling Leg

Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.

$28.00

Rack

$27.61

Door Handle

Screws are not included.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bought a new gas oven that did not come with a propane conversion kit.

  • Customer: Denny from Bishop CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Wrench set
  • 55 of 77 people found this instruction helpful
I followed the simple instructions that were included in the kit. I started by replacing the 5 orifices on the top burners. The orifices are well labeled with numbers and colors. Next, I tightened the broiler burner orifice and the oven burner orifice with a 1/2 inch wrench. I had to tighten them pretty good to get the flame down where it is supposed to be. ... read more

Stove was set up for natural gas and needed to be converted to LP

  • Customer: Ed from Orange TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 60 of 95 people found this instruction helpful
The LP conversion kit contained very good, detailed instructions. I replaced the gas orifices, took off the bottom door and adjusted the regulator.

Used the screwdriver to adjust the low flame and everything was done. read more

Oven light receptacle broken - bulb base broke off

  • Customer: Paul from Spokane Valley WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 16 of 20 people found this instruction helpful
Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snap... read more