Models > WWGF3002KWA

WWGF3002KWA Westinghouse Range - Overview

Get Parts and Repair Help for WWGF3002KWA

If you know the range repair part you need, you can browse the list of all parts on the WWGF3002KWA, or you can search by name or part description. You can also find your part by where it is located on the WWGF3002KWA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for WWGF3002KWA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$44.14

Oven Rack

Sold individually.

$7.64

ANTI TIP KIT

$26.07

Inner Oven Door Glass Panel

$63.71

Oven Thermostat - 125V 60Hz

This part establishes and maintains the internal temperature of the oven cavity.

$5.27

Screw

Sold Individually.

$7.09

Foot Leveling Leg

Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.

$44.55

Oven Door Seal with Clips

Also known as gasket.

$24.36

Thermostat Knob

$4.23

Steel Washer

Size: 3/4 inch od x 1/4 inch id

$111.82

Oven Igniter

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Safety valve would not open

  • Customer: Ed from Darby PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 61 of 78 people found this instruction helpful
I am an HVAC tech by trade so it wasn't difficult to diagnose problem with safety valve. The hard part was being without an oven for a week. Repair was simple and effective--oven works good as new.
Shut off gas and unplugged oven. Removed floor of oven between broiler and bake section, used wrenches to disconnect gas line from safety valve in back of... read more

Internal glass broke on the oven door

  • Customer: EDWARD from PHOENIX AZ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 21 of 22 people found this instruction helpful
All the was needed was a Phillips screw driver. It's not difficult. Watch out because the door is spring loaded and does seperate quickly after all the screws are out. Be sure to watch the front panel, it appears to be heavy glass and can come out of the slots during the repair. I only had to re-assemble and dis-assemble 4 times before I got it right but it'... read more

Oven light receptacle broken - bulb base broke off

  • Customer: Paul from Spokane Valley WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 20 of 25 people found this instruction helpful
Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snap... read more