WWEF3005KWB Westinghouse Range - Instructions

Pulled the range out, unplugged it, removed upper back panel, inserted lens through front of control panel, slid the notch on the actual light onto the lip on the back of the plastic lens. Done!

Unplugged range from power receptacle. Opened oven door to locate element. Using 1/4 inch nut driver,removed two mounting screws holding bottom element in place at back of oven. Pulled element forward to expose two(2) push-on terminals. Removed push-on clips from element terminals. Removed element from oven chamber and tested it for continuity. Determined that element had failed. Found part #on element and ordered new element on-line. Order placed on Sunday PM and part received just after noon on Tuesday. Installed new element which worked perfectly. Actual repair time about 20 min. 20

I followed the video on this website/youtube. Extremely ease.

Very simply following the online video instructions.

Super easy, was putting it back together when husband got home from work and decided that he needed to finish putting the last screw in

Just like the video showed, I unscrewed the old element, and screwed in the new one. Really that easy!

Take off nut and cover at rear off oven, both sides. Pull old element off (push on plug). Put replacement element in oven push on to wire plug, make sure it is on tightly. Push into oven wall, secure by replacing nut and cover. Your Job is complete.

I pulled the stove out away from the wall and unplugged it from the wall. I then proceeded to take all the screw/nuts out and disconnected what was left of old element and put new element through holes in back and put on the connectors and reinstalled the back and plugged it in and turned on the oven and it worked like a dream. Thanks PartsSelect for the speed and effiency of getting me part to me.

I order the part from you which I got in 1 day great shipping. took out the part and rescrewed the part in done in 5 mins would order again from you and recommend to all

removed old baking element and replace new base baking element very very easy

First, I disconnected the electrical power by pulling apart the plug behind the range. Next, I removed the screws holding the service plate on back of the top panel.I removed the switch knob by gently pulling it from the stem. Underneath I found 2 screws holding the switch in the panel. I removed these with a phillips screwdriver.I was able to pull the entire switch out to the rear leaving all wires attached.The new switch looked different from the original and the wires were configured differently but the wires were clearly marked. By removing one at a time and placing it on the new switch to the corresponding marking,it was a simple matter to wire the switch.I reinstalled the switch in the panel,put back in the screws to hold the switch, slid the knob back on the stem, reinstalled the rear panel,and plugged the power cord back in.The switch worked perfectly.

Watched the video on Partselect before ordering the part, to see what I was getting into. Part arrived super quick. Removed bad element just as video described, and installed new element in opposite direction. Job was complete, and super was in the oven in less than 15 mins after arriving home from work. Anybody can do this repair, don't waste your money on a service call!

first pulled the breaker, then removed the oven door. One wire came out easily but the other side would not budge so we had to take off the back of the range. They had cought the wire up in a loop and so it had no give. Removed it from the loop so if it ever needs to be replaced again we won't have the same problem. Used the advice from other comments and it went as discribed. I hope others also removed the door as I can't imagine how much harder it would be with the door in place.

Real easy to replace the heating element. Two screws and out came the old and in with the new one.

I had the part shipped directly to the rental house and the tenant installed it with no problem.