Models > WWC9000PAL

WWC9000PAL General Electric Washer - Overview

Get Parts and Repair Help for WWC9000PAL

If you know the washer repair part you need, you can browse the list of all parts on the WWC9000PAL, or you can search by name or part description. You can also find your part by where it is located on the WWC9000PAL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$13.80

Water Inlet Valve with Outlet Insert

This washing machine water inlet valve has two ports for water to enter.

$7.05

Hose Clamp Kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

$62.05

Four Port Pump

This washing machine pump is white in color and has four ports for water to pass through.

$1.70

Screw

This screw is sold individually.

$4.27

Levelling Leg Cap

$29.46

Agitator Coupling

This coupling is used for 20 spline drive shaft transmissions.

$5.55

Screw Kit - Package of 12

$3.21

Washer Package of 12

$14.52

Lint Filter

This lint filter goes on top of the agitator.

$6.41

SCREW-PKG 12

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced the Agitator coupling

  • Customer: jose from lAREDO TX
  • Difficulty: Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 30 of 39 people found this instruction helpful
First, you will need to remove the agitator, if it hasn't fallen off by itself. Than, you will need a pulley to remove the coupling from the spinning pole . I used one of those pulleys with three arms to remove it , Second, I lubricated the inside of the new coupling with a little oil, and sided it down on the spinning pole. It was a little hard to i... read more

old water pump was leaking, needed replacment

  • Customer: LLOYD from Moffett Field CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 21 of 22 people found this instruction helpful
## WHAT I WISH I'D KNOWN BEFORE I STARTED ##
1. Remove the four hoses first.
2. remove the three screws holding the pump to the structure above BEFORE loosening the flex clamp.
3. with the pump free of the hoses and rest of the washer, then remove the flex coupling clamp from the pump end only; do not remove the flex coupling from the motor.read more

Hot Water side barely running

  • Customer: Anthony from Tyler TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 17 of 19 people found this instruction helpful
First cut off both incoming water supplys. Next remove the water hoses to the inlet. Then remove some of the screws that are holding the back panel on that will give you access to the inlet plate remove those screws and that are holding the inlet in. when you remove the inlet mark the wires take of the water hose and remove inlet now do the opposite to assem... read more