All Installation Instructions for Westinghouse Dishwasher WWBD2400HW0

Old door gasket

Trim of 1/16 off door gasket with scissors left rubber at end Does not rub does not leak works great. Thank you very much. I was very satified

Parts Used:

Dishwasher Bottom Door Gasket

Steve from WOODBURN, OR
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Water leakage

Based on your video instructions on YouTube.Took off door cover. Put old gasket out. Installed the new one. Put door cover back .

Parts Used:

Dishwasher Bottom Door Gasket

Rimma from BROOKLYN, NY
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Old gasket melted.

Watched installation video and followed directions. All went smoothly.

Parts Used:

Dishwasher Tub Gasket - Gray

Al from WOODBURY, MN
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

The old gasket was leaking

The old Gasket came right off but it was a little tricky to put the new one on even tho I watch the video. I got the new one in place but it is still leaking going back to the drawing board

Parts Used:

Dishwasher Bottom Door Gasket

Chuck from UNION, NJ
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Leaking water

followed online video provided and it was a snap

Parts Used:

Dishwasher Bottom Door Gasket

Harold from SHELOCTA, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dishwasher overflowed when it was not running.

My husband had the water shut off to the dishwasher, he unplugged the electrical connection then disconnected the inlet water pipe with an adjustable wrench. Once that was done he disconnected the water inlet valve from the frame of the dishwasher and installed the new one , he then reconnected the inlet water pipe and the electrical connection , once that was done he opened the water valve feeding the dishwasher and checked for leaks which were none. Took him about 15 minutes to do it . Make sure you have the proper tools and a roll of Teflon tape before you start the job.

Parts Used:

Water Inlet Valve - 120V 60Hz

Ellen from BERGENFIELD, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Door broken would not close

1.Turn off electricity. 2. Remove two Phillips screws on either side of front panel 3. Remove front panel 4. Remove 6 screws from the old dispenser 5. Pull both wires connectors from dispenser 6. Remove dispenser 7. Install the new dispenser and reverse the steps

Parts Used:

Detergent and Rinse Dispenser with Cap

gerald from MILFORD, MA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

broken door spring on dishwasher

used pliers to hook up spring according to repair video.5 mins to check for proper tension.

Parts Used:

Door Spring

robert e from HOPATCONG, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Missing tub gasket

I think the videos on the site are awesome. Made both repairs after watching them. They explain the repairs in a simple to follow way.

Parts Used:

Dishwasher Bottom Door Gasket

Dishwasher Tub Gasket - Gray

John from FALLBROOK, CA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

gasket came out

ordered new gasket and watched utube video

Parts Used:

Dishwasher Bottom Door Gasket

tom from SELLERSVILLE, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Door would not stay closed

Followed the YouTube video. Replacement fit perfectly , only took 10 minutes to replace.

Parts Used:

Detergent and Rinse Dispenser with Cap

Niall from Schaumburg, IL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Replaced the side rollers in the dishwasher

Removed the old rollers with with screw driver. Used the original screws and washers, and reinstalled the new rollers. Had been having trouble with top dish rack metal slides popping out of the old rollers. I not that the replacement rollers are slightly larger and have slightly deeper groves for the slides. Have not had the new rollers installed long enough to see if they remedied the problem. Will know in a few weeks time. So far, so good.

Parts Used: