Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WWA7650SALAA

WWA7650SALAA General Electric Washer - Overview

Get Parts and Repair Help for WWA7650SALAA

If you know the washer repair part you need, you can browse the list of all parts on the WWA7650SALAA, or you can search by name or part description. You can also find your part by where it is located on the WWA7650SALAA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WWA7650SALAA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$8.21

D-Shaped Knob Insert Clip

Sold individually.

$6.59

Timer Knob Clip

$11.92

Selector Knob with Clip

This knob accepts a D-shaped shaft. Sold individually.

$13.19

V-Style Drive Belt

$15.29

Compression Ring

This compression ring works in conjunction with the timer dial.

$1.98

Screw

This screw is sold individually.

$11.33

Hose Clamp Kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

$4.15

Drain Hose Tie Strap

$72.98

Four Port Pump

This washing machine pump is white in color and has four ports for water to pass through.

$4.78

SCREW-PKG 12

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced broken START knob on dryer.

  • Customer: SAM from ROCK HILL, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 480 of 486 people found this instruction helpful
Slid off the old START knob, then pushed on the new START knob.

I created and printed a label on my computer for use with the time selector dial, which must be set at or beyond 10 minutes, before turning the START knob.

I made a label that says "Minimum" with a red arrow that points past the 10 minute setting on the time selector dial.<... read more

The inside of the Selector Knob was stripped

  • Customer: Frank from Irvine, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 373 of 376 people found this instruction helpful
Removed the damaged knob and replaced it with the new knob. Very ease read more

GE washer no spinning during spin cycle

  • Customer: Laurence from Bronx, NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 129 of 143 people found this instruction helpful
Used the spatula to release the front panel (push flat spatula under top about 2 inches from either side to release the two sprng clips holding the front panel on) to expose the tub and motor assembly. Inspected the belt and it seemed worn and a lot of rubber particles were in base of machine. Ordered the belt from partselect - received it two days later. Lo... read more