Models > WWA5826RBL

WWA5826RBL General Electric Washer - Overview

Get Parts and Repair Help for WWA5826RBL

If you know the washer repair part you need, you can browse the list of all parts on the WWA5826RBL, or you can search by name or part description. You can also find your part by where it is located on the WWA5826RBL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WWA5826RBL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.62

D-Shaped Knob Insert Clip

Sold individually.

$3.27

Timer Knob Clip

$5.54

V-Style Drive Belt

$1.70

Screw

This screw is sold individually.

$9.75

Compression Ring

This compression ring works in conjunction with the timer dial.

$13.80

Water Inlet Valve with Outlet Insert

This washing machine water inlet valve has two ports for water to enter.

$18.62

Timer Knob

Please be advised this part is redesigned and is now different from the original.

$62.05

Four Port Pump

This washing machine pump is white in color and has four ports for water to pass through.

$4.27

SCREW-PKG 12

$3.62

Drain Hose Tie Strap

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

GE washer no spinning during spin cycle

  • Customer: Laurence from Bronx NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 80 of 89 people found this instruction helpful
Used the spatula to release the front panel (push flat spatula under top about 2 inches from either side to release the two sprng clips holding the front panel on) to expose the tub and motor assembly. Inspected the belt and it seemed worn and a lot of rubber particles were in base of machine. Ordered the belt from partselect - received it two days later. Lo... read more

washer was not agitating or spinning

  • Customer: Rachelle from Kent City MI
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 34 of 36 people found this instruction helpful
My washer was making noise but not agitating or spinning on any of the cycles that I turned the dial to. Didn't know if it was the transmission or something simple. I did some research and discovered it may be the belt, even though the belt looked new, I changed it anyway by just removing the front of the washer and cutting the belt off and putting the new b... read more

old water pump was leaking, needed replacment

  • Customer: LLOYD from Moffett Field CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 22 of 23 people found this instruction helpful
## WHAT I WISH I'D KNOWN BEFORE I STARTED ##
1. Remove the four hoses first.
2. remove the three screws holding the pump to the structure above BEFORE loosening the flex clamp.
3. with the pump free of the hoses and rest of the washer, then remove the flex coupling clamp from the pump end only; do not remove the flex coupling from the motor.read more