Models > WWA5412GAL

WWA5412GAL General Electric Washer - Overview

Get Parts and Repair Help for WWA5412GAL

If you know the washer repair part you need, you can browse the list of all parts on the WWA5412GAL, or you can search by name or part description. You can also find your part by where it is located on the WWA5412GAL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WWA5412GAL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.27

Timer Knob Clip

$9.75

Compression Ring

This compression ring works in conjunction with the timer dial.

$1.70

Screw

This screw is sold individually.

$18.62

Timer Knob

Please be advised this part is redesigned and is now different from the original.

$4.27

Levelling Leg Cap

$7.33

Hose Clamp Kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

$4.27

SCREW-PKG 12

$62.05

Four Port Pump

This washing machine pump is white in color and has four ports for water to pass through.

$7.68

Friction Snubber Pad

This friction snubber pad is an inch and a half long.

$29.46

Agitator Coupling

This coupling is used for 20 spline drive shaft transmissions.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced the Agitator coupling

  • Customer: jose from lAREDO TX
  • Difficulty: Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 31 of 41 people found this instruction helpful
First, you will need to remove the agitator, if it hasn't fallen off by itself. Than, you will need a pulley to remove the coupling from the spinning pole . I used one of those pulleys with three arms to remove it , Second, I lubricated the inside of the new coupling with a little oil, and sided it down on the spinning pole. It was a little hard to i... read more

old water pump was leaking, needed replacment

  • Customer: LLOYD from Moffett Field CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 21 of 22 people found this instruction helpful
## WHAT I WISH I'D KNOWN BEFORE I STARTED ##
1. Remove the four hoses first.
2. remove the three screws holding the pump to the structure above BEFORE loosening the flex clamp.
3. with the pump free of the hoses and rest of the washer, then remove the flex coupling clamp from the pump end only; do not remove the flex coupling from the motor.read more

lost all gear oil bottom of transmission

  • Customer: opal from richmond KS
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set, Wrench set
  • 12 of 14 people found this instruction helpful
put washer on its side,removed 1cross section,loosened the nut that held on the pulley.
loosened the motor and removed drive belt,removed drive pulley,removed old seal,poured in 90 weight gear oil,installed new seal and done everything else in reverse order.
stood washer upright connected water hoeses,waste water discharge hose,set washer to spinan... read more