Models > WWA5407MAL

WWA5407MAL General Electric Washer - Overview

Get Parts and Repair Help for WWA5407MAL

If you know the washer repair part you need, you can browse the list of all parts on the WWA5407MAL, or you can search by name or part description. You can also find your part by where it is located on the WWA5407MAL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WWA5407MAL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.27

Timer Knob Clip

$6.63

V-Style Drive Belt

$13.80

Water Inlet Valve with Outlet Insert

This washing machine water inlet valve has two ports for water to enter.

$9.75

Compression Ring

This compression ring works in conjunction with the timer dial.

$1.70

Screw

This screw is sold individually.

$18.62

Timer Knob

Please be advised this part is redesigned and is now different from the original.

$4.27

Levelling Leg Cap

$7.33

Hose Clamp Kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

$4.27

SCREW-PKG 12

$62.05

Four Port Pump

This washing machine pump is white in color and has four ports for water to pass through.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

GE washer no spinning during spin cycle

  • Customer: Laurence from Bronx NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 68 of 77 people found this instruction helpful
Used the spatula to release the front panel (push flat spatula under top about 2 inches from either side to release the two sprng clips holding the front panel on) to expose the tub and motor assembly. Inspected the belt and it seemed worn and a lot of rubber particles were in base of machine. Ordered the belt from partselect - received it two days later. Lo... read more

washer was not agitating or spinning

  • Customer: Rachelle from Kent City MI
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 32 of 34 people found this instruction helpful
My washer was making noise but not agitating or spinning on any of the cycles that I turned the dial to. Didn't know if it was the transmission or something simple. I did some research and discovered it may be the belt, even though the belt looked new, I changed it anyway by just removing the front of the washer and cutting the belt off and putting the new b... read more

Replaced the Agitator coupling

  • Customer: jose from lAREDO TX
  • Difficulty: Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 31 of 41 people found this instruction helpful
First, you will need to remove the agitator, if it hasn't fallen off by itself. Than, you will need a pulley to remove the coupling from the spinning pole . I used one of those pulleys with three arms to remove it , Second, I lubricated the inside of the new coupling with a little oil, and sided it down on the spinning pole. It was a little hard to i... read more