Models > WWA3657SALWH

WWA3657SALWH General Electric Washer - Overview

Get Parts and Repair Help for WWA3657SALWH

If you know the washer repair part you need, you can browse the list of all parts on the WWA3657SALWH, or you can search by name or part description. You can also find your part by where it is located on the WWA3657SALWH by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WWA3657SALWH parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.27

Timer Knob Clip

$5.54

V-Style Drive Belt

$1.70

Screw

This screw is sold individually.

$9.75

Compression Ring

This compression ring works in conjunction with the timer dial.

$18.62

Timer Knob

Please be advised this part is redesigned and is now different from the original.

$4.27

SCREW-PKG 12

$3.62

Drain Hose Tie Strap

$7.68

Friction Snubber Pad

This friction snubber pad is an inch and a half long.

$4.27

Levelling Leg Cap

$7.33

Hose Clamp Kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

GE washer no spinning during spin cycle

  • Customer: Laurence from Bronx NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 80 of 89 people found this instruction helpful
Used the spatula to release the front panel (push flat spatula under top about 2 inches from either side to release the two sprng clips holding the front panel on) to expose the tub and motor assembly. Inspected the belt and it seemed worn and a lot of rubber particles were in base of machine. Ordered the belt from partselect - received it two days later. Lo... read more

washer was not agitating or spinning

  • Customer: Rachelle from Kent City MI
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 34 of 36 people found this instruction helpful
My washer was making noise but not agitating or spinning on any of the cycles that I turned the dial to. Didn't know if it was the transmission or something simple. I did some research and discovered it may be the belt, even though the belt looked new, I changed it anyway by just removing the front of the washer and cutting the belt off and putting the new b... read more

Old belt wore out and stretched, wasn't driving tub through spin cycle.

  • Customer: Joseph from Hollywood FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Wrench set
  • 14 of 17 people found this instruction helpful
I loosened the four nuts holding the motor in place, slid the motor toward the tub to slacken the belt enoug to remove it, then replaced old belt with new belt, pulled motor back in place until belt was tight, then tightened the four nuts holding th emotor in place. read more