Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WW30430P

WW30430P Jenn-Air Wall Oven - Overview

Parts and Repair Help for models starting with WW30430P

If you know the wall oven repair part you need, you can browse the list of all parts for models starting with WW30430P, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for WW30430P parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with WW30430P

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$29.46

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$5.15

Screw

This screw is sold individually.

$39.83

Door Hinge

This hinge is located on each side of the oven door.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$22.22

2 Piece Broiler Pan

The top of this part is now black.

$53.90

Bake Element

This bake element is found on the bottom of the oven.

$43.60

Oven Rack

Sold individually.

$61.61

Broil Element

This broil element is found on the roof of the oven.

$50.55

SEAL- DOOR

This oven door gasket prevents heat from escaping the oven cavity when in use.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 110 of 127 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 47 of 60 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

Oven door wouldn't close completely

  • Customer: William from Statesville, NC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 30 of 33 people found this instruction helpful
Parts arrived in three days and it was an easy swap of the hinges but the same problem still existed: the oven door wouldn't close completely, so the oven light stayed on and the convection wouldn't work either unless the door closed all the way. The replacement hinge's springs apparently aren't strong enough to close it and the springs aren't adjustable - w... read more