Models > WU3000V1

WU3000V1 Roper Dishwasher - Overview

Get Parts and Repair Help for WU3000V1

If you know the dishwasher repair part you need, you can browse the list of all parts on the WU3000V1, or you can search by name or part description. You can also find your part by where it is located on the WU3000V1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for WU3000V1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.96

Rubber Washer

Sold individually. Used with the heating element.

$3.51

Lid Spring

This metallic spring is for your dishwasher's soap cup cover.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$5.54

Touch-Up Paint - White

$2.70

Screw - 8-18 x 1/2

Sold Individually.

$20.34

Detergent Dispenser Cover Kit

This kit also includes the lid hinge pin, spring, snap and latch.

$2.70

Cover Screw

Sold individually.

$144.23

Upper Dishrack Kit

The dishrack kit comes with the dishrack, rollers, adjustable tines, and clips. Must be assembled. Note: This part has been redesigned by the manufacture. Blue is no longer avail...

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dishwasher Not Draining

  • Customer: Lewis from Portsmouth NH
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 81 of 114 people found this instruction helpful
Ordered both drain & wash impeller kit and the drain check valve with o-ring. Decided to test the cheaper drain check valve first. Pulled dishwasher out from wall & adjacent cabinetry; removed drain hose from disposer and drained as much water as possible; "jacked" side of dishwasher to gain access to drain hose and drain check valve; used pliers to remove ... read more

Tines were broken and rack was damaged

  • Customer: Dennis from Littleton CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 32 of 56 people found this instruction helpful
Replaced the dish rack.

Removed the retaining clips on the front of the rail and removed the old rack.

Removed the spray arm assembly from the old rack.

Assembled the new rack, with the supplied parts from the kit. Using the old rack to know where some parts needed to be placed.

Put the spray arm assembly on the... read more

Leaky water inlet valve

  • Customer: Jack from Fort Worth TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Wrench set
  • 17 of 20 people found this instruction helpful
Easy. Removed screws at top holding dishwasher to counter. Turned off water to dishwasher. Unhooked water supply line. Electrical and waste lines were long enough to leave connected and pull dishwasher out, set on side. Pull off electrical connector. Use pliars to compress spring holding water line to dishwasher, remove that line from valve. Use nut d... read more