Models > WTW6700TW2

WTW6700TW2 Whirlpool Washer - Overview

Get Parts and Repair Help for WTW6700TW2

If you know the washer repair part you need, you can browse the list of all parts on the WTW6700TW2, or you can search by name or part description. You can also find your part by where it is located on the WTW6700TW2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WTW6700TW2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$111.50

Drain Pump

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$2.70

Hose Clamp

$25.05

Basket Hub Kit

$60.88

Suspension Rod Kit

This part helps center and support the drum, transmission and motor assembly. There are 4 rods in this kit.

$71.82

Lid Lock Assembly

Also known as Latch. As per the factory, this part uses the magnet to latch and the magnet is only available with the inner lid.

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$3.86

Touch-Up Paint - White

$4.60

Lid Hinge Mounting Screw

Sold individually.

$94.04

Water Inlet Valve with Wire Harness

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loose change entered drain pump, cracked housing leaked all water out

  • Customer: ROBERT from BARRINGTON IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Socket set
  • 93 of 102 people found this instruction helpful
Disconnect power, hot/cold supply and drain hose. Tip washer onto front side, expect some additional water to leak out. Remove the cracked drain pump, 3 screws, hose clamps, and electrical plug.

Tip washer back up, use the putty knife to pop the top cover up (clips are about 6.5in in from sides). Unclip the white plastic cover over the outer and i... read more

Water pump for draining

  • Customer: Kerry from Alleyton, tX TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Socket set
  • 26 of 27 people found this instruction helpful
The actual install of the pump was extremely easy. I removed the back cover, (After unhooking water, drain and electricity. I laid the machine on its front ( USE CAUTION WHEN DOING THIS, THERE ARE SHARP EDGES on the FRAME) After bandaging my cut fingers, I used a nut-driver/screwdriver to remove the screws, pliers to remove the Spring clamps, unhooked the wi... read more

cracked water pump from change

  • Customer: Kevin from Mount Gilead OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 19 of 21 people found this instruction helpful
first flipped washeron its front, took water pump off, put new water pump on and flipped it back upright.
then took basket out of washer to get remaining change out of washer. fairly simple the third time it has to be done,
I also put two short screws into the suction screen of the pump so that no change can reach the pump anymore read more