Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WTVC833PUS-10

WTVC833PUS-10 Bosch Dryer - Overview

Get Parts and Repair Help for WTVC833PUS-10

If you know the dryer repair part you need, you can browse the list of all parts on the WTVC833PUS-10, or you can search by name or part description. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Heating Element Assembly

The heating element assembly found in dryers is what generates the heat required for the drying cycle. If your dryer is not heating, or not getting hot enough you will need to test...




High Limit Thermostat - 195 Degrees

This high limit thermostat is a safety mechanism used in dryers. It is a temperature control switch that helps regulate the internal temperature of your gas or electric dryer. When...


Door Latch - White

A door latch is also known as a door strike, this part is made of plastic and it is located on the inside of the dryer door. This part latches into the door catch, located on the front of your dryer, when the door is closed. The door latch and door catch work together to ensure the dryer door remains closed for the entire drying cycle. If your latch is broken or worn out the door on your dryer may not close properly, or may not close at all. This replacement part is approximately 1.25 inches long and 1 inch wide.


Light Bulb - 120V 10W

Sold individually. This bulb has a European intermediate base.






Temperature Sensor Regulator

Temperature sensors, also known as temperature regulators, are used in gas and electric dryers to help manage the internal temperature of your appliance. If your dryer is getting no heat, or not getting enough heat, you might have an issue with your temperature sensor. You can test the resistance of the sensor in your dryer with a multi-meter. Check the owner?s manual for the appropriate level of resistance, and test the resistance at room temperature. Depending on the model, your dryer may use more than one sensor. This replacement part is simple to install, and it is sold individually.


Drive Motor


Temperature Sensor

An NTC sensor, or thermistor helps regulate the internal temperature of your appliance. This part monitors the temperature and tells the control board what temperature your appliance is running at. If it is too hot the thermistor will tell the control board and it will stop sending heat into the appliance, and once it has cooled the control board will then start heating again. If the sensor is not working properly your appliance might trip, you might notice it will not run, it will not start, it will turn itself off mid-cycle, or it may not heat properly. First you want to ensure there is no debris around the sensor, and that the NTC terminal connectors are not loose, it might be as simple as tightening the connection or cleaning the senor. If everything appears to be in working order and it is still not functioning properly you can test this part at room temperature with a multi-meter. Before repairing your appliance make sure it is unplugged.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

no heat on the dryer

  • Customer: David from Southlake, TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Did a quick on line search of the problem and found the Limiter Switch is normally the solution.....loaded the model number in the PartSelect data base and received the correct part the next day (standard shipping)! Replaced the part in about 45 mins and works perfectly. While I was ordering the Limiter switch I figured it was a good time to replace the dr... read more