Models > WT4801CW

WT4801CW (ABWEEUS) LG Washer - Overview

Get Parts and Repair Help for WT4801CW

If you know the washer repair part you need, you can browse the list of all parts on the WT4801CW, or you can search by name or part description. You can also find your part by where it is located on the WT4801CW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$21.46

Sensor Assembly

$1.95

Clamp

$121.11

LID ASSEMBLY

$8.18

HOSE ASSEMBLY,DRAIN

$45.78

Hose Assembly,Drain

$160.04

HOUSING ASSEMBLY,CLUTCH

$62.66

VALVE ASSEMBLY,INLET

$20.07

DECOR,LID

$15.41

Coupling Assembly

$10.52

Leg Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

LE Error Message and won't spin drum properly

  • Customer: Mark from Harrisburg PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 84 of 100 people found this instruction helpful
I first tested the motor per the service manual. I checked the resistance between the terminals of the 3 pin connector. It's supposed to be 5-15 ohms. The motor checked out so I replaced the main electrical board. It turns out that wasn't the problem. After a brief web search I found out that the hall sensor (which is attached to the motor stator) was t... read more

Humming, no error code, not spinning

  • Customer: Brian from Camden MO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
The problem ended up being the pump motor which discharges water from the washer. I figured out this was the problem after trying several things. I determined the motor was fine when it was empty. With the unit turned off, if you can rotate the tube with a quick spin and it lights up, probably this is OK. Then I tried to run it again and it went about 1/2 wa... read more