Models > WSXH208F1WW

WSXH208F1WW General Electric Washer - Overview

Get Parts and Repair Help for WSXH208F1WW

If you know the washer repair part you need, you can browse the list of all parts on the WSXH208F1WW, or you can search by name or part description. You can also find your part by where it is located on the WSXH208F1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the WSXH208F1WW [Viewing 3 of 3]

$15.16

Door Catch

Sold individually.

$107.86

Shock Absorber Assembly

This assembly comes with two shocks, four nuts, one leveling leg pin and instructions. These shock absorbers keep the washer from vigorous shaking during it's cycles.

$137.54

Drain Pump

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$54.46

Tub Spring with Sleeves

Sold individually.

$5.55

SCREW-LOCK 10-16X 50

$70.91

Drain Hose

$231.73

Door Lock Assembly

$74.96

Water Inlet Valve

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

$151.41

KIT-BELLOWS & MTG SPRING

$146.27

Outer Door - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken Spring & broken level-shock.

  • Customer: STEWART from STOKESDALE NC
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 12 of 13 people found this instruction helpful
Disconected power & hoses. Removed 4 screws from two tabs at rear of top. Slid top fwd & up to remove. Removed two screws from lower front panel and removed panel. Removed back cover screws and back cover. Placed sling arround tub & lifted with 2"X4" on strap placing additional wood under sling supported by edges of machine. Removed one scred and loosened mo... read more

The water pump becomes very noisy

  • Customer: Roger from Hudson WI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 9 of 11 people found this instruction helpful
This is the second time in the same 7 year old appliance. Remove the front bottom cover by removing 2 screws. Then remove the 2 screws holding the pump down. Then unclip the electrical wire from the pump and remove both hoses from the pump by squeezing the spring clamps with a pliers. Have a pan to collect the water that will drain from the lines. Take ... read more

hard to detect leak that caused floor damage

  • Customer: Dawn from Perrysburg OH
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 6 of 7 people found this instruction helpful
After pulling the appliance out and repairing the laminate floor. It was not apparent that there was any major leak. No puddles of water or moist areas in the washer drain compartment. After reloading with clothes and starting there was a very tiny drip in the trap boot around the back side due to a wire from a bra poking through. After removal of trap a... read more