Models > WSSH300G0WW

WSSH300G0WW General Electric Washer - Overview

Get Parts and Repair Help for WSSH300G0WW

If you know the washer repair part you need, you can browse the list of all parts on the WSSH300G0WW, or you can search by name or part description. You can also find your part by where it is located on the WSSH300G0WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the WSSH300G0WW [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.23

Door Catch

Sold individually.

$67.11

Door Handle

$112.54

Shock Absorber Assembly

This assembly comes with two shocks, four nuts, one leveling leg pin and instructions. These shock absorbers keep the washer from vigorous shaking during it's cycles.

$129.55

Drain Pump

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$5.98

SCREW-LOCK 10-16X 50

$108.05

Water Valve

$53.61

VANE

$285.30

Bellow Kit with Mounting Springs

The bellow is also known as boot seal.

$66.43

BELT

$2.73

SCREW #12 FLAT HEAD 10

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken Handle due to poor design

  • Customer: Charles from Marathon FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 19 of 25 people found this instruction helpful
Unscrew 2 screws. Replace handle with the same screws. read more

Washer would not drain

  • Customer: Jack from Canyon Lake TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 15 of 25 people found this instruction helpful
Removed 2 Hose clamps with pliers. Unplug power source from drain pump. Unscrew 2 mounting screws with 5/16" nut-driver then replace unit in reverse sequence...... Very simple. read more

broken shock absorber

  • Customer: leslie from circleville OH
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 6 people found this instruction helpful
after pulling pins and installing new shocks, the washer still made loud ,disturbing sounds during use. Did some more investigating, turns out the inner bearings on the drum are bad. Apparently a problem with this model. Probably why the original shocks broke in the first place. read more