All Installation Instructions for General Electric Washer Dryer Combo WSM2700LCW

Dryer was squeeking for a while, and then eventually just quit working.

Took the top and the front panel off (took me a while to figure this out without breaking stuff). Took off belt, pulled out drum, replaced bearing, and then I also had to replace the ball (attached to rear of drum, which slides inside the bearing).

Parts Used:

Rear Bearing

Jesse from Battle Ground, WA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

4 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

load noise

took the top off, then the front,there 2 screws that hold the front on. there's a yellow thing on the front took that off, it is held on with one screw. on the back of the dryer on the bottom is a metal plate take that off, to get to the belt take that off. then there' 3 screws in the drum, take them off ,then you can slid the drum out. then take 2 screws off the bearing bracket, that's it. easy

Parts Used:

Rear Bearing

DRYER BEARING BRACKET

jeff from coldwater, MI
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

5 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dryer making squeeky noise.

Removed the Drum and replaced the part....

Parts Used:

Rear Bearing

NICOLAS from LYNN, MA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench set

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Lack of grease caused bearing to go out

I took the top and front off the dryer. I then took the screws out of the drum and removed the drum. I then took the old bearing out and put the new one in.

Parts Used:

Rear Bearing