Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WSM2400LBB

WSM2400LBB General Electric Washer Dryer Combo - Overview

Get Parts and Repair Help for WSM2400LBB

If you know the washer dryer combo repair part you need, you can browse the list of all parts on the WSM2400LBB, or you can search by name or part description. You can also find your part by where it is located on the WSM2400LBB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer dryer combo. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Hose Clamp Kit

This is a water hose clamp kit for a variety of appliances including dishwashers and washers. This is a genuine replacement part. The kit includes two hose clamps. The smaller of t...


V-Style Belt

This v-style belt or drive belt is designed for use in your washing machine. This part connects the drive motor to the drive system in the washer, which spins the basket. If you notice a burning smell when your washing machine is operating, or if your machine pumps but will not spin, you may have to replace the v-style belt. This part is cloth-covered. This product measures approximately 10 inches in diameter and is sold individually. This is an OEM part sourced directly from the manufacturer. Be sure to disconnect the power source from the washing machine before you begin this repair.


Washer Package of 12


Water Inlet Valve

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Lint Filter


Industrial Sealant

Red 3M800

Lint Filter Housing with Bulkhead







Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

belt worn causing machine to make all kinds of noise

  • Customer: Kenneth from Baltimore, MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 18 of 25 people found this instruction helpful
pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!! read more

drive belt replacement

  • Customer: Scott from Cumming, GA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 4 of 5 people found this instruction helpful
removed rear panel, tilted machine forward, removed four bolts holding the pump and loosened the connection to the motor shaft,(several times dropped socket and without magnet to retrieve tools would have been much more difficult),removed two hoses, dropped pump assembly, replaced belt, and reversed the process to re-assemble. Easy to find part and will defi... read more

Worn out belt replacement

  • Customer: DAVID from WAPAKONETA, OH
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
First unplug power cord and removed water hoses, then removed rear panel of machine. Shop-vac old debries out of machine Remove small spring holding belt tensioner pulley assembly. Remove hex key from motor shaft that connects to the pump. Use pliers to spin clamps out of way so you can then remove the (4) four bolts that hold pump to bottom of the motor, no... read more