Models > WRT8G3EQ2

WRT8G3EQ2 Westinghouse Refrigerator - Overview

Get Parts and Repair Help for WRT8G3EQ2

If you know the refrigerator repair part you need, you can browse the list of all parts on the WRT8G3EQ2, or you can search by name or part description. You can also find your part by where it is located on the WRT8G3EQ2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for WRT8G3EQ2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$23.12

Door Shelf Retainer Bar

$26.04

Door Shelf Retainer Bar

Sold individually.

$21.78

Defrost Timer - 60Hz 120V

This defrost timer will cycle for thirty minutes after every eight hours of run time.

$24.23

Drawer Support Rail - Right Side

This drawer track supports the right hand side of the sliding drawer.

$47.87

Crisper Glass Shelf Insert

Glass only.

$56.46

Fresh Food Door Gasket

This white fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air outside.

$24.23

Drawer Support Rail - Left Side

This drawer rail supports the left hand side of the sliding drawer.

$17.42

Defrost Thermostat

The thermostat senses that the heat near the cooling coils has reached the desired temperature.

$5.14

Screw

$72.08

Evaporator Fan Motor Kit

This kit includes the motor, clips and terminal connectors. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

evaporator coil kept freezing up, refridgerator warm.

  • Customer: Greg from Hanover Township PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 62 of 72 people found this instruction helpful
This was the second part I tried. The defrost timer was first, but that did not fix it. To do this I had to remove the ice maker and the back plate of the freezer. Then I defrosted the coil and cut the wires. stripped them back and installed the new thermostat. re-assembled and tested. has been working great ever since. read more

Refrigerator door gasket torn

  • Customer: Matthew from Washington DC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 59 of 63 people found this instruction helpful
No instructions included, so it took a little bit of staring at the new part to figure out how it works. The barbed ridge on the gasket fits into a slot on the door. The flat face of the gasket has an internal magnetic strip that helps keep the seal tight against the steel face of the refrigerator. Installation requires no tools. This is the basic process:read more

Refrigerator would not run but interior light was on.

  • Customer: Bruce from Alton IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 57 of 74 people found this instruction helpful
I unplugged the refrigerator, then opened the door and removed four screws holding the plastic electrical panel to the interior top of the main refrigerator compartment and noticed the cold control was corroded badly, apparently from moisture in the panel. I ordered a new one from partselect.com. When it arrived the next day, I then pulled off the control ... read more