Models > WRT21NRCW2

WRT21NRCW2 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for WRT21NRCW2

If you know the refrigerator repair part you need, you can browse the list of all parts on the WRT21NRCW2, or you can search by name or part description. You can also find your part by where it is located on the WRT21NRCW2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for WRT21NRCW2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.21

Defrost Timer - 60Hz 120V

This defrost timer will cycle for thirty minutes after every eight hours of run time.

$21.75

Door Handle

This white handle can be used with both the freezer door and the fresh food door of many refrigerators. Note: As per manufacture this handle includes the mounting block and screw for the top of the handle, If you need the screw for the bottom it must be ordered separate

$3.56

Door Shelf End Cap - Left or Right Side

This end cap can be used for the right or left side of the refrigerator door shelf or the freezer door shelf.

$3.27

Door Shelf End Cap - Left or Right Side

It can be used for either the right side or the left side of some refrigerator door shelves.

$19.35

Run Capacitor

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$12.91

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fahrenheit.

$42.04

Door Shelf Retainer Bar

This is a white cut-to-fit door shelf retainer bar.

$3.37

Crisper Drawer Cover Support

$24.12

Evaporator Fan Motor Kit

This motor runs the evaporator fan in your refrigerator. It is mounted on the center hub and has three lead wires terminals. This motor rotates in a clockwise fashion. Its shaft ha...

$23.91

Evaporator Fan Blade

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge got warm and freezer coils were frosted

  • Customer: Stephen from Warrington PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 171 of 190 people found this instruction helpful
Fridge is a side by side. The freezer is pretty narrow for a guy with wide shoulders.

Pulled plug.

Had to remove bottom drawers then used nut driver to remove screws closest to back wall in drawer runners. Once the back screws were removed the runners could be swung up or down out of way so back cover could be removed.

On... read more

Door handle broke off

  • Customer: Lisa from Linton ND
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 64 of 70 people found this instruction helpful
First I removed the top screws, then I slide it off the lower screw that is hidden behind the handle. I replaced the handle by sliding it onto the bottem first then attaching it onto the top with the two top screws. read more

Noisy fan

  • Customer: Jordan from Maumee OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 61 of 71 people found this instruction helpful
1. Removed the 7 nuts using the nut driver from the freezer back panel inside the freezer.
2. Remove the back panel. The evaporator motor and fan are located above the coils.
3. Unplug the wiring harness.
4. Remove the two gold mounting screws holding the motor and fan in place.
5. Remove the motor and fan including the brackets.
6. ... read more