Models > WRT18G4AW4 > Instructions

WRT18G4AW4 Westinghouse Refrigerator - Instructions

All Instructions for the WRT18G4AW4
376 - 390 of 520
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
refer quit cooling and so did freezer
I replaced the defrost timer,defrost thermostat,and run cap.as it turned out the compressor went bad. I dont know the model because but the time I got this review I replaced the refer with a knew one . two weeks living out of coolers was so much fun !!!!!!!!
Parts Used:
Run Capacitor
  • jerry from petaluma, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Original parts broke when shelf was overloaded
Snap old parts out, put new parts in
Parts Used:
Door Shelf Retainer Bar End Cap - Right Side Door Shelf Retainer Bar End Cap - Left Side
  • Karl from Woodbury, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Broken shelf glass
Insert the replacement glass shelf in my refrigerator. Installation was very easy and simple, no tools needed.
Parts Used:
Crisper Glass Shelf Insert
  • Laurie from Chicago, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Aii the part was very easy to install
Just unstrew the old part and srew the new part less than 15 minutes
Parts Used:
Drawer Support Rail - Right Side Refrigerator Door Shelf Retainer Bar - Cut to Fit Door Shelf Retainer Bar End Cap - Right Side Door Shelf Retainer Bar End Cap - Left Side
  • idowu from Gaithersburg, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Freezer wouldn't go in to defrost cycle
After some troubleshooting to ensure the thermostat and heating element were working, determined that the defrost timer was the problem. With the defective part, I was able to manually advance the timer to activate the defrost cycle, but it wouldn't do so on its own. Unplugged the refrigerator from the wall. Timer is located in the refrigerator compartment at the very top. The compartment houses the cooling thermostat, the light bulb and the defrost timer. Using 1/4" nut driver, remove 4 screws holding compartment cover to top of fridge. Lower a bit to access electrical wiring. Wiring harness can be unplugged to work on the timer away from the fridge which makes it a bit easier. Timer is mounted with 2 phillips head screws. Remove screws and unplug timer from wiring. Install new timer, plug in wiring, secure with the phillips head screws and remount entire compartment.
Parts Used:
Defrost Timer - 60Hz 120V
  • John from Long Beach, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
broken crisper glass
easy
Parts Used:
Crisper Glass Shelf Insert
  • Charles from Rogers, AR
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Faulty defrost timer. Freezer would not maintain temperature
Watched the video once. Removed four 1/4 inch screws with a nut driver unplugged the unit, took out two screws securing the timer. Replaced did all of this in about 10 minutes. It was "exactly" as the video showed and it's worked perfectly since the replacement of the faulty timer. I saved a $75.00 service call minimum and the part was more than likely cheaper from Part Select than from the repair facility. Although I'm a pretty good handy man, you would not need any experience to make this repair. The instructions are precise and the part fit perfectly.
Parts Used:
Defrost Timer - 60Hz 120V
  • Steve from Nineveh, IN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Frig did not run
Simply replaced the defrost timer located inside the frig just behind the temp dial. Very easy job. Removed the 3 screws holding the temp sw and light assembly. Removed the defrost timer w/ 2 screws and put i all back together. 15 mins at most. Suggest you watch the install video for pointers.
Parts Used:
Defrost Timer - 60Hz 120V
  • hugh from delray beach, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Old gasket was torn causing excessive moisture in refrigerator.
Removed door, removed old gasket, cleaned surfaces where gasket sealed, replaced gasket, re-installed door. About 10-15 min.
Parts Used:
Refrigerator Door Gasket
  • Joseph from Cape Coral, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
not cold enough
per the video..easy installation....unfortunately the temperature did not improve. We still have a refrigerator temp in the upper freezer.....and a "cooler" in the refrigerator section
Parts Used:
Run Capacitor
  • Gary from Hudson, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
When I opened the door, sometimes the light was not turned on.
With the help of a knife we took out the light switch unplugged it, plugged in the new one and it started working.
Parts Used:
Light Switch
  • Helen from Burnsville, MN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
refrigerator was missing retainer bars
The bars just snapped into the end caps which in turn snapped into the door. Easy-peasy!
Parts Used:
Refrigerator Door Shelf Retainer Bar - Cut to Fit Door Shelf Retainer Bar End Cap - Right Side Door Shelf Retainer Bar End Cap - Left Side
  • Jeanine from Marstons Mills, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Missing Retainer Bar
Opened box, inserted end caps, mounted into refrigerator door. Done
Parts Used:
Refrigerator Door Shelf Retainer Bar - Cut to Fit Door Shelf Retainer Bar End Cap - Right Side Door Shelf Retainer Bar End Cap - Left Side
  • Daniel from Hollywood, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
drawer support rail broke just behind the front of the rail.
Unloaded the shelf and removed shelf. unscrewed the one screw and removed the rail. inserted new rail and replaced the screw. DONE.
Parts Used:
Drawer Support Rail - Right Side
  • William from Buckeye, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Refrigerator too Warm
tested the thermostat, cleaned the coils, checked seals all clean. defrost timer did not cycle so replaced it but issue not resolved. even though freezer was working while refrigerator was problematic, proceeded to open freezer panel. discovered that fan was not pushing cold air into refrigerator compartment due to ice build up in connecting tubes. cleaned ice and replaced panels to positive result
Parts Used:
Defrost Timer - 60Hz 120V
  • Raymond from Yorktown Heights, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the WRT18G4AW4
376 - 390 of 520
Back to Top