Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WRT13CGBD1

WRT13CGBD1 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for WRT13CGBD1

If you know the refrigerator repair part you need, you can browse the list of all parts on the WRT13CGBD1, or you can search by name or part description. You can also find your part by where it is located on the WRT13CGBD1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for WRT13CGBD1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$13.80

Defrost Timer - 60Hz 120V

Defrost timers are part of the defrost circuit in your refrigerator and freezer. This timer cycles the defrost heater on and off. For every eight hours, the appliance timer will cy...

Order within the next 1 hr and 40 mins and your part ships today!
$28.41

Run Capacitor

The run capacitor helps the compressor kick on and off while maintaining a constant temperature in your fridge and freezer. You may need to replace your run capacitor if your refrigerator or freezer section will not start, if they are too warm, or if your refrigerator has become too noisy. Replacing the run capacitor is a relatively easy project. For this repair you will only need a 1/4 inch nut driver and needle nose pliers. Remember to disconnect the power and water supply line to the unit before you begin this repair. For full step by step instructions, simply click on the video below.

Order within the next 1 hr and 40 mins and your part ships today!
$6.68

Light Bulb

This OEM 40 watt appliance light bulb is used for some ranges, refrigerators, freezers, and microwaves. Simply locate the existing bulb, unscrew it from its socket, and replace wit...

Order within the next 1 hr and 40 mins and your part ships today!
$58.49

Evaporator Fan Motor Kit

The evaporator fan motor kit is specifically made for your refrigerator to run the evaporator fan in your refrigerator. It is mounted on the center hub and has three lead wire terminals; its shaft has a diameter of 1/8 inches and is 1-1/4 inches long. The function of the evaporator fan motor is that it supplies air to the evaporator coils which then circulate cool air throughout your refrigerator, efficiently keeping your fresh food compartment cold. The tools you will need for this installation include a 1/4 inch nut driver, and a pair of wire strippers. Keep your hands protected during this repair by wearing work gloves.

Order within the next 1 hr and 40 mins and your part ships today!
$7.71

SOCKET

The light socket on your refrigerator houses the light bulb and connects it to the power source. If you notice that your refrigerator light does not come on when you open the door,...

Order within the next 1 hr and 40 mins and your part ships today!
$5.21

Door Shelf End Cap - Left Side

Order within the next 1 hr and 40 mins and your part ships today!
$44.38

Door Shelf Retainer Bar - Cut to Fit

This is a white cut-to-fit door shelf retainer bar.

Order within the next 1 hr and 40 mins and your part ships today!
$6.02

Door Shelf End Cap - Right Side

This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.

Order within the next 1 hr and 40 mins and your part ships today!
$15.70

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fah...

Order within the next 1 hr and 40 mins and your part ships today!
$3.67

Door Shelf End Cap - Left Side

Order within the next 1 hr and 40 mins and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge got warm and freezer coils were frosted

  • Customer: Stephen from Warrington, PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 297 of 349 people found this instruction helpful
Fridge is a side by side. The freezer is pretty narrow for a guy with wide shoulders.

Pulled plug.

Had to remove bottom drawers then used nut driver to remove screws closest to back wall in drawer runners. Once the back screws were removed the runners could be swung up or down out of way so back cover could be removed.

On... read more

Noisy fan

  • Customer: Jordan from Maumee, OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 129 of 145 people found this instruction helpful
1. Removed the 7 nuts using the nut driver from the freezer back panel inside the freezer.
2. Remove the back panel. The evaporator motor and fan are located above the coils.
3. Unplug the wiring harness.
4. Remove the two gold mounting screws holding the motor and fan in place.
5. Remove the motor and fan including the brackets.
6. ... read more

Clicking sound then within a minute clicking again, not cooling.

  • Customer: Melvin from Semmes, AL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 74 of 86 people found this instruction helpful
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby r... read more