Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WRS6R3EW4 > Parts

WRS6R3EW4 Westinghouse Refrigerator - Parts

All parts for the Westinghouse Refrigerator WRS6R3EW4

Below is a list of all parts for the Westinghouse Refrigerator WRS6R3EW4 - White. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the WRS6R3EW4
1-14 of 269
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$24.71

Door Bin

Door bins, also known as cantilever shelves, are storage bins located on the door of your refrigerator. Over time, a cold refrigerator can cause plastic to become fragile and break...

$3.92

Crisper Cover Support - Front

This crisper cover front support is used to keep the crisper shelf in place, and may need replacing if the door will not open or close. This part can be used for the front support and mounts to the inside cabinet wall. Replacing this part is an easy repair, but will require a small flat blade screwdriver, a putty knife, and a soft hammer. Remove the crisper and shelf from the refrigerator before replacing the support. The crisper cover front support is held in place with a locking pin. To remove the old part, you will first need to push the pin into the interior of the cabinet using the screwdriver, and then you can pull the support out with a putty knife. After removing the pin and attaching the new support, simply use the soft hammer to lock the new pin in place.

$31.02

Door Shelf

This white bin can also be used on the freezer/refrigerator door on some models. Sold individually.

$4.31

Crisper Support - Rear

Replacing the rear crisper support in your refrigerator is an easy job, but to complete this repair you will need a small putty knife, a punch or a short flat blade screwdriver, and a small hammer. You may need to replace your rear crisper support if you find that the door will not open or close. In order to complete this repair, you will need to remove all the shelves above the crisper in order to have ample room to work. This part is made from plastic and mounts on the inside of the wall. It is also good to have duct tape on hand, which can be used to protect the liner around the support. This part is sold individually.

$59.10

Water Inlet Valve

The water inlet valve is also known as the water inlet valve assembly and is compatible with your refrigerator. The function of this part is to release water from the supply line w...

$37.77

Door Bin

Gallon size. Sold individually.

$54.85

Upper Crisper Drawer Cover - Glass NOT Included

This cover holds up the top crisper drawer, and has drawer glides molded in it.

$8.17

Hinge Bearing

Sold individually. Also known as a short door closing cam.

$14.48

Defrost Thermostat Kit

If you find that there is excessive frost in your freezer, or the freezer will not defrost, you may need to replace the defrost thermostat. The defrost thermostat kit comes with th...

$97.59

Ice Maker with Cover - 8 Cube

This Frigidaire ice maker includes the ice mold and control device. The ice maker receives water from the water inlet valve and stores water in the ice mold until it freezes. Ice is automatically ejected and the process continues until the storage bucket is full. Your ice maker should be replaced if ice is not being generated, stored, dispensed, or the ice maker has been damaged. Replacing the ice maker is an easy job and only requires a 1/4 inch nut driver. Before you start this repair, make sure your refrigerator is unplugged. For help with this installation, check out the video below.

$39.01

Crisper Drawer Cover - NO Glass

This part contains molded glide rails for the crisper pan. It does not come with the glass shelving. The glass is not included. Must be ordered separately.

$33.81

Evaporator Fan Motor Kit - 120V 60Hz

The evaporator fan motor circulates air through the food compartment for efficient cooling in refrigerators. The evaporator is located in the back of the freezer and it circulates the air over the refrigerator coils. The evaporator motor fan in your refrigerator should be replaced if the fridge section is too warm, the freezer section is too warm, orthe evaporator motor makes loud noises or stops working completely. The tools used for this repair are a 1/4 nut driver and wire strippers. *Please note: The motor has been updated by the manufacturer. Tip to detect if motor is not working, often if it fails it generates loud noises in the freezer area. For safety, make sure food is safely stored so it does not deteriorate while the power is off, and remember to unplug fridge.

$28.41

Run Capacitor

The run capacitor helps the compressor kick on and off while maintaining a constant temperature in your fridge and freezer. You may need to replace your run capacitor if your refri...

$27.54

Door Closing Cam

Sold individually. This cam is located at the bottom of the fridge/freezer door.

All Parts for the WRS6R3EW4
1-14 of 269