WRS3R3EW0 Westinghouse Refrigerator - Instructions

husband did it took only a few min part was easy to find

Easy to assemble after cutting original water line fittings off. Use sharp knife to keep from damaging end of water lines.

take of the tray & take parts out & installed the new ones

I figured out why no water and ice at door dispenser. Only a problem comes from a water supply valve. So I ordered parts assembly, and parts were arrived within 3 days. I replaced it, and then it worked OK since then. Regarding door shelf, it was cracked. So I replaced within 5 minutes. Anyway, I wanted to know when my parts arrive, so I called your Canadian operator, she was very nice. Just I want to say to manufacture of refrigerator, I wish they used batter parts. Because my refrigerator is less than two years old.

Removed the old, slid in and pressed down the new, and that was it.

Removed the nuts on top - to loosen the door. Lifted the door off the hinge. Took out old part, put in new one, reinserted door, replaced nuts.

It was so easy the light socket came right out took out old undid clips (light was melted to socket)put new socket piece in reattached clips...light works...as far as the door not closing...unscrewed on screw took off plastic clip put it in and put the hinge bearing on top...put refrigerator door back on...first top then squeeze bottom on...I bet I saved over $150.00 dollars if I called a repair man for a 15 minute job...your website made the job alot easier discribing what the problem was and parts need...easy to follow....thank you

All instructions included on this site are good. I would add only one thing to them. When removing the 4 water lines from the old unit be sure to pull up on the white rings while you pull down on the water lines. All else is a snap.

I removed the top hinge cover, loosened the hinge so I could remove the door and laid the door on it's side. I removed what was left of the Door Closing Bearing and istalled the new parts. Set the bottom of the door on the lower hinge then postioned and set the top hinge into place and tightened the top hinge and installed the hinge cap.

removed cover from top hinge,then hinge r&r bottom cam plate reinstalled door. now no noise opening door,ice naker is very simple turned water off to frig loosened two screws and unpluged wiring.harness is a little long. took a while to make ice next morning it was working fine

i was trying to figure it out but eventually it fix it self even when i get the part the problem seems to be fix on its own i unpplug the eletrical cord from the wall for over three hours and plugged back in and after 2 more hours it works so i am confussed dont know what happen i did not change any part so i have one brand new inlet water

It was simple... After paying $280 for a repair man to come out and install some unnecessary part to the fridge when I told him "everything on the Internet points to a thermostat repair." He disagreed, fixed the fridge and said the freezer would work more efficiently now. It didn't, so I bought a new fridge/freezer, put the old one in the basement. I ordered the thermostat (under $20), put it in, and now (knock on wood), works great and I have a beer fridge for the man cave

I followed the instructions on the Video and it was very helpful and I completed the job in 15 minutes. Greatest web site for helping with repairs. I would certainly reccommend this web site to anyone that would perform their own repairs

Ordered the part online and it came the next day. No problem putting in the new bin; it took less than a minute and no tools required.

Easily installed the new ice-maker. Rec'd the part in three days.