WRS26MR4JS8 Crosley Refrigerator - Instructions

Hooked them into place. No muss, no fuss. Bins were delivered in a timely manner, and they were the correct ones!

Installed the door bins, quickly and easily. I was very impressed with your quick delivery and your customer service. Also excellent, my whole buying experience was excellent. Thank you.

1. Turn off water in line to refrigerator. 2. disconnect hose from refrigerator. 3. Remove back cardboard panel at bottom of refrigerator. 4 Remove 2 screws holding in the valve assembly at bottom right. 5. best way I found to remove hoses (all color coded) is to cut with razor knife at the white collar. cut clean and square. 6. disconnect electrical (also color coded) 7. connect hoses to valve assembly by pushing hose firmly into hole. If you are familiar with PEX then this is the same. Reconnect electrical. Reconnect to refrigerator... 3,2,1 your done. It will take a couple cycles to get the air out of the lines.

Took out the old one and pushed in the new one. Easy, peasy.

Simple installation - just pop into place! We thought they were a bit overpriced, but we certainly can't complain about the service - EXCELLENT!

It was easy. Watched the short video and placed the part right in. The part came a lot fasted then we thought. Thank you partselect.

Followed the instructions from another person in the Part Select water valve section and from the video on the same page. Excellent instructions and very easy installation. Water dispenser and ice maker began performing properly as soon as the refrigerator was plugged back in to the power.

We decided to get a new fridge, after the " sticker shock " of new refrigerators we decided to repair the one we have. Two screws and one plug and the ice maker was replaced, took out the broken crisper shelf, put in the new one and that was done, instructions were great. I actually had to watch a " how to " video, ( provided by your web site ) to change the shelf support, very easy. thanks, Gary Hoyle

after watching the video I followed to the tee used the screw driver tapped out the old peg and removed the stem in minutes I was tapping in the new parts

Took out the old and put in the new! Piece of cake!

If this happens to you the first thing I would do is shut off the freezer and, using a hair dryer, melt the ice in the ice maker and heat up the water inlet to make sure it is not froze up. Turn the freezer back on and wait to see if that cures the problem. If not, order the new water inlet valve and follow the simple instructions in the video provided on the PartSelect website. I have never have a more pleasant experience with any parts/repair service than I did with PartSelect. After ordering that part it came within the time they stated and their help with the install was great. Also helpful were the other customers talking about their problems and solutions.Thanks to PartSelect I now have Ice and a happy wife. Happy wife--happy life.

The bins don't easily snap into place, you have to twist them a little to make them fit into the support nubs. The trick is not to twist them too far or they'll split.Ours do, and now we store half-gallon OJ and milk back where the containers belong.

The new inlet valve came with pisco connectors so had to cut the end of the tubes off. Before doing this I marked all the tubes to make sure they were replaced in the correct order. The pisco connectors are great to use and very quick. The total install time was about 20 to 30 minutes. While you have the back of the frig off make sure you vaccuum the fan and coils. It was making ice in less than 20 minutes.

Removes broken bin and installed the new one. No tools needed. Very easy.

thought it was the o ring ...summer cottage thought i winterized everything ..ouch filter element cracked three screws a parts direct .com order ....1/4 inch nead screws nut driver or 1/4 inch ratchet ,,in and out and you can re=use the "push=lock" elbows