WRS26MF5ASQ Crosley Refrigerator - Instructions

Used a nut driver to remove the small panal from the back of the refrigerator. Removed the two screws holding the valve in place. Unscrewed the water lines from the old valve and cut the ends off of them. Push the water lines back into the new valve. Unpluged the wiring from the old valve and installed them in the new valve. reinstalled the new valve and put the cover back on. Tested system for proper operation.

Replaced the ribbon from circuit board in door to the circuit board which controls the water and ice dispenser and back light. Unplug the refrigerator before any repair is attempted. You can short the boards when replacing the cable. Remove the front plate where the buttons are. Be careful, it slides up then out. once you remove the outer panel, you will see the ribbon which attaches to the front panel to the circuit board in the door (of course freezer side). on the plate you just removed, there is a white cover plate secured with four small philip head screws. Don't try to replace the ribbon without removing this cover. If you do, you run the risk of breaking the the ribbon and then you'll have to order another one. Make sure you note which way the cable is inserted. Insert the cable in both slots on the door and panel. Replace the screws and front panel.

i dissasamble the water & ice dispenser and substitued the ribbon cable for the new one.

Pushed the bins in place,very easy.

Put in the new one!

Crusher housing had broken so I ordered the part and replaced it. I have since put it back together twice. When I first installed it it crushed the ice no problem. From that point on it seems to lock up and won't crush the ice, cube ice works but the blades seems to hang up after the first use. I can turn the cog by hand but I have to turn it backwards a few times before it turns freely, however it still won't crush the ice. I took it apart and put it back together again. Same thing happened after the first time I tried it. Can you help me. The old crusher broke into. Could something else be locking up?Thanks for the help

Very simple, pulled out the old ice reservoir which contains the feed ice crusher & blade attatched to the shaft. Emptied the old ice tray instaalled thre new tray (after washing & drying) & put it place make sure the motor drive meshed with the new shaft drive. Lowered the ice detector arm & away it went. Probably took 10-15 minutes. I tried to fix the old one twice & spent maybe 3-4 hrs but the repairs never lasted very long.

Replaced the broken bin

snapped the wires from frig onto the proper prong and viola,it works. The proper prong is identified by the size because there are two prongs with the wires and two connecting prongs in the socket. I talked to a very helpful representative and she gave me the number for Frigidaire, when I was confused by the placement of the wire. Wish I had remembered her name to share with you. As it turned out I didn't need to call Frigidaire.

Installed the bins on the doors,no tools req.

By removing the old water filter and installing the new one

Just popped it in..didn't fit really well...had to force it some what which I didn't like but same drawer. Good to go.

Replaced bin in door. Noi tools needed

Took out two screws, installed new parts, put screws back in. Done.

Installed new valve.There are several pieces of tubing coming off of the valve. Pay close attention to where they go. Color coordination is poor on the new valve.