WRS23W0AW6 Westinghouse Refrigerator - Instructions

Punch out center of old support, then pull it out. Insert new suppport, insert center and tap flat with hammer. All done!

Took off bolts on top hinge , lifted the door off lower hinge With a srew driver was able to remove an replace both parts .
The doors is as good as new :0)

It was very easy to install. Simply removed the top plate on the fridge door. It was one screw. then removed the door and replaced the plate and bearing. The plate needed to be screwed in. Placed the door back on and replaced the top plate. Done! Easy and fast.

The part was perfect. Did it on a Saturday night is about 3 minutes. Wa the total fix.

took out bottom plate where the glass sets removed 3 screws at bottom lifted up on face plate and pulled out the cover (unplug controls) 3 more screws and operating unit was out. Important....unplug electrical connection on the left side 2 screws to remove actuator and replaced with new one.
Reverse steps.

piece of cake... removed upper hinge, old bearing hinge came right out ... Installed new piece and was done in less than 5 minutes... It took longer removing all the stuff from the door shelves,then it did to fix the problem.

First I removed two screws and my wife took the door our. Peplaced part and we put the door back in. Two more screws and done.

It's not so much the ease of the repair that matters as how quickly you got the part to me. I had tried to order the part frmo a major company who's name rhymes with Beers, but they were unable to deliver it after three weeks. It was constantly on backorder. I ordered it from you on Monday, had the part on Tuesday, and had repaired it by Tuesday night.

Amazing service and turn around. You are to be congratulated.

Thanks to everyone is thread, for the valuable info. Over-all, the whole thing was pretty easy.

Removed one phillips screw holding top cover (top of door).
Removed top cover (about 6" long).
Removed two hex nuts (sorry, I've forgotten the size).
Removed door.
Removed broken (bottom) bearing-hinge.*
Replaced bearing hinge.
Replaced door.
Replaced hex nuts.
Replaced top cover.
Replaced phillips screw.

I wasn't sure how heavy (or rather not heavy) the door was, so I had an additional person stading by (it's not heavy). Extra person was not necessary.

The only thing that made the repair annoying was when I tried removing the cracked bearing-hinge, the top splintered and the bottom half was stuck in the door. I ended up having to dig out the cracked piece with pliers & drill & tiny computer screw-driver & swearing.

Moral of the story is don't crack the top off of the bearing-hing that you're trying remove.

It snapped in place.

I followed the excellent directions in the video linked to the email from PartSelect. The installation was quick and easy. I rated the whole operation "a bit difficult" because, if I had seen the video before I removed the old part, I would have known that you tap the support's center rod gently INTO the wall instead of wrestling it violently OFF the wall.

I watched the "how-to" videos on your website, and followed the instructions. It was very easy, took about 10 minutes, and now the door works like new.

I used the paint spatula to pry out the old part and then put in the new part and pushed in the holder with my fingers. Super easy.

Removed cover from top bracket with phillips sd. removed bracket with socket wrench; lifted door from hinge; removed remnants of old hinge from recess, this took a while because it had broken inside, eventually I used needle nose pliers to break it up and pull it out in three parts; installed new bearing hinge; reset door, and installed bracket and cover.

Easy!

ordered the part, watched the video....it was a snap