WRS23MF5ASF Westinghouse Refrigerator - Instructions

Removed old filter...put in new...ran water for three minutes before drinking. Easiest repair/replacement job ever!!!

Unscrew it, rusted, but doable, install the new part, screw it back, the problem is to fit the little hose in the same hole properly, so we created a tool like a piece of wire to elongate it and make it fit again, screw the cover, and Eureka, like new. So happy.

Pried the broken support insert out with a screw driver and pulled it out with pliers, then inserted the new and pressed it in and Presto the drawer now works good again.

Punch out center of old support, then pull it out. Insert new suppport, insert center and tap flat with hammer. All done!

took the back off refridgerator, disconnected water valve assembly, then disconnected water lines and electrcal connectors. also i received the part in less than 24 hours

1-Remove upper plate with phillips screw driver (6) screws 2- remove upper hinge plate with ratchet and socket (2) bolts 3- lift door off bottom cam, lay door flat on floor. 4- Remove broken cam on lower part of door, just pull out. 5- Install new cam in bottom of door 6- raise door up, set on cam, reinstall top bolts and screws 7- p. S. Make sure you trace top hinge location with a pencil before removal, so installation has proper location.

Very easy repair, instruction were clear and easy to follow

I just simply inserted the bin

Removed the old, installed the new one and finally figure out we had to press the reset button.

Simple, I had a repair man come over and diagnose the problem. After confirming, I ordered the part and replaced it. Need to make sure you get the ice build up out of the fitting tnat goes from the back of the fridge connection at the top and the filler tube inside the unit, mine was iced over. Repair man wanted to charge me $250.00... with his service call and buying the part, it cost $120

all above

I took out the old filter and put in the new filter. I ran some water through it and it was done.

I took the top door plate off lifted up the door and uncrewed the broken part and installed the new one. Lifted the door and placed post into bushing. Viola the door worked better than when it was new

I took out the drawer, then the whole shelf. I unscrewed the track that was broken and screwed in the new one. I then, put the shelf back in the fridge and put in the new drawer. All works awesome!!!
Thanks PartSelect for getting me the parts I needed so fast!

Ordered the part from PartSelect. Estimated time for slow delivery seven days. I got it in three. Removed the cover from the water and ice maker dispenser arena held on by three screes. I had to use an easy out on one rusted scree. Disconnected the wiring to the switches and lat the Circuit Board come forward by removing three small screws. Using tweezers to catch the screws, I removed two small screws holding the broken actuator and put the new one in its place making sure the spring was properly located and the ice maker swivel was under the hold-down strip along with the new actuator. I reassembled the door cover and got a drink of cold water. By the way, always unplug the refrigerator because that area is hot. Dr Robert E McGinnis author of In Search Of Paradise and many other fine books found on Amazon.