WRS23MF5ASA Westinghouse Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Had multiple supports snap off the side walls
It was pretty easy. The hardest part was getting the supports that had snapped off out of the walls of the refrigerator. Once that was accomplished it was a breeze.
Parts Used:
-
Brandon from Atlanta, GA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
the refrigerator door was hard to close, and upon inspection I finally decided that the light switch was making the door hard to close.
I removed the door actuated light switch with my index finger and thumb on my right hand. I then removed the two wires from the switch. I noticed that the new switch had different look to it,I think Frigidaire must have had a problem with the original design of the switch. Reassembly was just replacing the two wires and putting the new switch in place, and no more door closing problem.
Parts Used:
-
Paul from Springfield, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
2 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The drawer slide had cracked and was no longer holding the drawer in place
I had removed the current cover from the refrigerator by lifting it out of place. I removed the glass insert and placed it in the new crisper cover. I placed the new assembly into position, added the drawer back into the drawer slides, then the refrigerator was back to new!
Parts Used:
-
LJ from McCordsville, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Needed new water filter...
No problem. Just push the button and pop out the old filter, pop in the new one, and reset the indicator by pressing and holding the "filter reset" button on the control panel.
I also needed to replace the water actuator handle on the front panel ice and water dispenser panel. That took a few more minutes to do but I wanted to share that I ordered the actuator arm from the Sears parts store at the same time that I ordered the filter from Parts Select. (parts select showed it out of stock and Sears showed it in stock).
I got notification that they were going to ship my part from Sears on the same day that the part from Parts Select arrived at my doorstep. It took about a week and a half more time to get the part from Sears and they charge more money on top of that.
Parts Select is my new parts store.
I also needed to replace the water actuator handle on the front panel ice and water dispenser panel. That took a few more minutes to do but I wanted to share that I ordered the actuator arm from the Sears parts store at the same time that I ordered the filter from Parts Select. (parts select showed it out of stock and Sears showed it in stock).
I got notification that they were going to ship my part from Sears on the same day that the part from Parts Select arrived at my doorstep. It took about a week and a half more time to get the part from Sears and they charge more money on top of that.
Parts Select is my new parts store.
Parts Used:
-
Eileen from Sun City West, AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator was missing a door shelf bin when we moved in
I found the part here on partselect, received it, and then installed the bin. Now I have enough room for all the little items in the refrigerator. The longest part of the repair was waiting for the part to arrive, which was Very Fast! I was impressed that the part arrived so quickly! Will Definitely keep partselect.com in my home repair contact list!
Parts Used:
-
Kathryn from Alexandria, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken shelf support
Punch out center of old support, then pull it out. Insert new suppport, insert center and tap flat with hammer. All done!
Parts Used:
-
Karl from Manchester, NH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drawer support was broke
Pried the broken support insert out with a screw driver and pulled it out with pliers, then inserted the new and pressed it in and Presto the drawer now works good again.
Parts Used:
-
Edward from Chandler, AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
was not making ice
took the back off refridgerator, disconnected water valve assembly, then disconnected water lines and electrcal connectors. also i received the part in less than 24 hours
Parts Used:
-
john from glen ellyn, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice maker failed to make ice
Removed lower cardboard cover, shut off water supply valve, unpluged frig. Used wrench to remove 3/8 water line from water valve, removed electrical connectors from solenoids, used fingers to unscrew water connections from valve.
Parts Used:
-
Leon from Mission Viejo, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Wrench (Adjustable)
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
door sagging
-
Meredith from Prattville, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
1 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
water filter needed changed
Removed old filter...put in new...ran water for three minutes before drinking. Easiest repair/replacement job ever!!!
Parts Used:
-
Joanna from Lock Haven, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken water activator
Unscrew it, rusted, but doable, install the new part, screw it back, the problem is to fit the little hose in the same hole properly, so we created a tool like a piece of wire to elongate it and make it fit again, screw the cover, and Eureka, like new. So happy.
Parts Used:
-
Natasha from East Meadow, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken Cam On Bottom Of Right Door
1-Remove upper plate with phillips screw driver (6) screws 2- remove upper hinge plate with ratchet and socket (2) bolts 3- lift door off bottom cam, lay door flat on floor. 4- Remove broken cam on lower part of door, just pull out. 5- Install new cam in bottom of door 6- raise door up, set on cam, reinstall top bolts and screws 7- p. S. Make sure you trace top hinge location with a pencil before removal, so installation has proper location.
Parts Used:
-
David from Laquinta, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers, Socket set
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water valve went out
Very easy repair, instruction were clear and easy to follow
Parts Used:
-
Alan from Victor, ID
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
drawer and track broken
I took out the drawer, then the whole shelf. I unscrewed the track that was broken and screwed in the new one. I then, put the shelf back in the fridge and put in the new drawer. All works awesome!!!
Thanks PartSelect for getting me the parts I needed so fast!
Thanks PartSelect for getting me the parts I needed so fast!
Parts Used:
-
Dawn from lake in the hills, IL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!