Models > WM2487HWMA

WM2487HWMA (ABWEEUS) LG Washer - Overview

Get Parts and Repair Help for WM2487HWMA

If you know the washer repair part you need, you can browse the list of all parts on the WM2487HWMA, or you can search by name or part description. You can also find your part by where it is located on the WM2487HWMA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$49.29

Drain Pump and Motor Assembly

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. Note: Pump casing is not included.

$15.41

Water Inlet Valve - Hot

$10.52

Tub-to-Pump Drain Hose with Bellows

This hose has bellows to allow for flexibility during the wash and spin cycles.

$1.96

Locking Pin

The locking pin is used to hold the shock absorber on the washer. There is a pin used at the bottom and top of the shock absorber. Sold individually.

$8.18

Gasket

$22.86

Bearing,Ball

$34.68

Bearing,Ball

$53.75

Circulation Pump Motor - 120V 60Hz

On a washer, this part is used for circulating the water. On a dishwasher, it is used for draining the water.

$6.34

Box Assembly,Detergent

$20.11

Sensor Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Washing maching wouldn't drain

  • Customer: Jorge from Apple Valley CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 130 of 170 people found this instruction helpful
Removed the top of the washer by removing the 4 back screws and 2 small brackets. Then I removed the front panel, this was actually the hardest part, 2 screws and 8 tabs that you pop out carefully from the top of the panel. I only disconnected the power button and was able to rest the panel on top of the washer. The rest of the washer came apart quickly just... read more

LE Error Message and won't spin drum properly

  • Customer: Mark from Harrisburg PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 81 of 97 people found this instruction helpful
I first tested the motor per the service manual. I checked the resistance between the terminals of the 3 pin connector. It's supposed to be 5-15 ohms. The motor checked out so I replaced the main electrical board. It turns out that wasn't the problem. After a brief web search I found out that the hall sensor (which is attached to the motor stator) was t... read more

dispenser would not stop filling with water

  • Customer: Debra from Reseda CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 12 of 27 people found this instruction helpful
replaced the cold water valve inlet read more