Models > WM2233HW

WM2233HW LG Washer - Overview

Parts and Repair Help for models starting with WM2233HW

If you know the washer repair part you need, you can browse the list of all parts for models starting with WM2233HW, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with WM2233HW

$15.41

Water Inlet Valve - Hot

$39.37

Inlet Valve Assembly

This valve is used for cold water, bleach dispenser and prewash cycles. It has a standard hose fitting inlet with 2 outlets facing 45 degrees to the right and one outlet facing 45 degrees to the left.

$10.52

Tub-to-Pump Drain Hose with Bellows

This hose has bellows to allow for flexibility during the wash and spin cycles.

$1.96

Locking Pin

The locking pin is used to hold the shock absorber on the washer. There is a pin used at the bottom and top of the shock absorber. Sold individually.

$8.18

Gasket

$22.86

Bearing,Ball

$34.68

Bearing,Ball

$6.34

Box Assembly,Detergent

$66.44

Gasket

Also known as a door boot seal or bellow and comes with a drain hole.

$20.11

Sensor Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

LE Error Message and won't spin drum properly

  • Customer: Mark from Harrisburg PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 83 of 99 people found this instruction helpful
I first tested the motor per the service manual. I checked the resistance between the terminals of the 3 pin connector. It's supposed to be 5-15 ohms. The motor checked out so I replaced the main electrical board. It turns out that wasn't the problem. After a brief web search I found out that the hall sensor (which is attached to the motor stator) was t... read more

Bellows had developed a small hole

  • Customer: Verle from Malcolm NE
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Removed the old bellows (2 squeeze hose clamps and one screw adjustable hose clamp) slid on the new one and it was done! read more

Pool of water under washer after a run

  • Customer: Daraius from AUSTIN TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Did the repair entirely from the back.- 4 screws back cover comes off. Once you see the Bellows it is obvious what needs to come off and there are other videos on the net showing this. The main things I did differently were 1) Leaned the washer forward and placed 3 2x4 blocks of wood under each back leg. This allowed me to reach under the washer with one ... read more