Models > WLE83300

WLE83300 Whirlpool Range - Overview

Get Parts and Repair Help for WLE83300

If you know the range repair part you need, you can browse the list of all parts on the WLE83300, or you can search by name or part description. You can also find your part by where it is located on the WLE83300 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for WLE83300 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$4.46

Screw

This screw is sold individually.

$5.54

Touch-Up Paint - White

$18.07

2 Piece Broiler Pan

$2.70

Screw

This screw is sold individually.

$109.18

Large Surface Element - 2500W

$101.62

Bake Element

This bake element has push-on wire terminals and is found at the bottom of your oven cavity.

$21.14

Single Drawer Roller

Used to slide the broiler drawer open and closed.

$106.18

Surface Element - 2200W

$2.70

Installation Screw

This screw is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Right Front Surface Element would not heat

  • Customer: Robert from Blackwood NJ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 41 of 46 people found this instruction helpful
Turn off the power to the Electric Oven.
Remove the 2 screws to the oven top at the front of the stove. Lift the oven top up. Have someone hold it for you. Label the wires that go to the element you are going to replace. Disconnect the wires from the Element. Remove the screw from the bracket that holds the front and rear element in place. It is located... read more

the 2500 watts element-surf was opened (wasn't heating)

  • Customer: luis from Lincoln NE
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 16 of 18 people found this instruction helpful
1 Turn the circuit breaker that feds power to the range/stove off
2 Opened the oven door and found two screws that hold the top part of the range. I removed the screws and disconnected the green cable (ground) so I could have access to the Element-surt
3 Disconnected the four wires that connects the Element and removed the braket that holds it.read more

Stovetop element burned out

  • Customer: Lonnie from Ashton ID
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 14 of 16 people found this instruction helpful
First of all, I shut off the electricity to the stove.

I had to remove the two screws holding the stovetop in place. I then lifted it up and braced it to keep it from falling, removed the bad element, carefully marking the 4 wires that were connected to the element. I then disconnected the wires, and removed the two brackets holding the elemen... read more