Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WFW9700VA00

WFW9700VA00 Whirlpool Washer - Overview

Get Parts and Repair Help for WFW9700VA00

If you know the washer repair part you need, you can browse the list of all parts on the WFW9700VA00, or you can search by name or part description. You can also find your part by where it is located on the WFW9700VA00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WFW9700VA00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.20

Touch-Up Paint - White

18ml

$11.07

Spray Paint - 12 oz. - White

$20.85

Shipping Bolt Kit

This kit includes both the upper and lower shipping bolts. 4 in total.

$16.89

HOSE

$27.40

SCREW-KIT

$30.41

PLATE

$29.30

HOSE

$22.94

Spray Paint Flo-Coat - Gray - 12 ounces

Can be used to re-coat dryer drums.

$18.17

Detent Wheel Kit

This includes numbers 4, 5 and 6 in the diagram.

$12.41

Cap, Lock Foot

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bellows were moldy, needed to replace

  • Customer: Franck from Annandale, VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 272 of 290 people found this instruction helpful
The first step is to remove the retainer ring that holds the outside of the bellow in place.
To do this, Open the washer door as far as you can to get it out of the way. look underneath of the front of the bellow on the outside of the washer where it meets the door. Put your head almost on the floor and look up.
You will find a spring streached... read more

F 21 error

  • Customer: Andrew from St.Louis, MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 200 of 227 people found this instruction helpful
Removed the front panel unplugged
The washer drained water out, lift the washer up to un screw the drain pump. Then unhooked the hoses from pump put the other pump in. read more

Washer made loud banging noise during spin cycle

  • Customer: Francis from Rochester, NY
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Wrench (Adjustable)
  • 83 of 100 people found this instruction helpful
I first removed the back panel held on by about 10 screws. I removed the drive belt from the pulley, then removed the lock nut securing the pulley to the drum & removed the pulley. Attached the new pulley to the drum, tightened on the lock nut, attached the new belt & ran a spin cycle. When that went OK I replaced the back panel & the washer was back in s... read more