Models > WFW95HEXL0

WFW95HEXL0 Whirlpool Washer - Overview

Get Parts and Repair Help for WFW95HEXL0

If you know the washer repair part you need, you can browse the list of all parts on the WFW95HEXL0, or you can search by name or part description. You can also find your part by where it is located on the WFW95HEXL0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WFW95HEXL0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Hose Clamp

$5.54

Touch-Up Paint - White

$43.61

Flowmeter

This part continually measures the amount of water entering the tub. It will make adjustments if too much or too little water is present.

$8.17

Spray Paint - 12 oz. - White

$25.38

SENSOR

$2.72

Water Inlet Hose Washer

Sold Individually. Order quantity needed.

$9.80

INLET HOSE

$7.77

FOOT

$2.70

CLAMP

$26.53

DIVIDER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F/H error code.

  • Customer: Jeff from Naples FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 26 of 31 people found this instruction helpful
Removed the top (3-4 screws at back). Flowmeter has 2 hoses with hose clamps. Removed with plyers. Simple electrical connector removed.

Reversed procedure. Running perfect now.

How did I know it was the flow-meter? Read the service manual as possible causes to narrow it down. Disassembled old flowmeter and cleaned. That fixed for awh... read more

Scratches in Surface

  • Customer: Michelle from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 10 of 12 people found this instruction helpful
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great. read more

FH code-4 minutes into cycle

  • Customer: robert from LITLE RIVER SC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 8 of 9 people found this instruction helpful
remove 3 screws of top panel at rear. slide top to rear 1/2 inch and lift up. disconnect wire to flometer, remove clamps on hoses and remove, reverse to install. did not fix problem. ck'd screens at fill valves. ordered new fill valves--problem solved. solenoids must not have been opening up all the way. read more