Models > WFW9351YW00

WFW9351YW00 Whirlpool Washer - Overview

Get Parts and Repair Help for WFW9351YW00

If you know the washer repair part you need, you can browse the list of all parts on the WFW9351YW00, or you can search by name or part description. You can also find your part by where it is located on the WFW9351YW00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WFW9351YW00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$111.63

Drain Pump

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. It has two ports for water to pass through: ...

$116.27

Bellow - Gray

This part is also called the Door Boot Seal. It's the main seal between the front bulkhead and the outer tub.

$3.76

Door Strike/Hook

Used to help make the door stay closed.

$2.70

Hose Clamp

$5.25

Touch-Up Paint - White

$19.50

Tub to Pump Hose

$71.59

Door Lock Latch

$2.70

Hose Clamp

This hose clamp is sold individually.

$18.05

Dispenser To Tub Hose

$30.15

Baffle, Tub

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F 21 error

  • Customer: Andrew from St.Louis MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 117 of 138 people found this instruction helpful
Removed the front panel unplugged
The washer drained water out, lift the washer up to un screw the drain pump. Then unhooked the hoses from pump put the other pump in. read more

Door latch module was defective

  • Customer: Carlton from Greer SC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 45 of 52 people found this instruction helpful
This model is a front-loading washer. The spring loaded retainer for the front of the boot must be removed, then the boot can moved to the side exposing the module. Remove the two screws holding the model, pull the model out, remove the three electrical plugs, then reverse this procedure to install new module. read more

water pump failed

  • Customer: Kurt from Caliente NV
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 31 of 34 people found this instruction helpful
Pump started making noises like ball bearings grinding. took the lower front cover off pulled the strainer out of the pump housing and found $2.55 in nickles dimes and quarters. Some 223 bullets and about 20 bobby pins. Together they had destroyed the impeller, so ordering a new one and installing it did the trick. Easy installation about 15mins. read more