Models > WFW560CHW3 > Instructions

WFW560CHW3 Whirlpool Washer - Instructions

All Instructions for the WFW560CHW3
1 - 3 of 3
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Washer hoses due for replacement
Replaced each hose. Did discover that either hose can be used for hot or cold water lines. No longer required to label hot and cold replacement hoses.
Parts Used:
Fill Hoses 5 Feet - 2 Pack
  • James from PINE MOUNTAIN, GA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
no problem just the wait for the part oct to dec.
putting the kit-stack was easy to put together
Parts Used:
KIT-STACK
  • brian from FUQUAY VARINA, NC
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washer Would Drain But Not Spin
Removed rear cover (6 screws) unpluged harness from motor control and removed same. Replaced motor control reinstalled harness. Replaced rear cover. Parts used motor control board.
Parts Used:
STACK KIT FOR LONG VENT DRYER
  • Nelson from Middletown, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers, Wrench (Adjustable)
0 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the WFW560CHW3
1 - 3 of 3
Back to Top