Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WFU1150EW1

WFU1150EW1 Westinghouse Freezer - Overview

Get Parts and Repair Help for WFU1150EW1

If you know the freezer repair part you need, you can browse the list of all parts on the WFU1150EW1, or you can search by name or part description. You can also find your part by where it is located on the WFU1150EW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for WFU1150EW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the WFU1150EW1

[Viewing 4 of 4]

Manuals & Care Guides for WFU1150EW1

Click to download
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$8.13

Defrost Thermostat

This refrigerator defrost thermostat is a genuine OEM part and is sourced directly from the manufacturer. Located on the back wall of the freezer section in the refrigerator, the d...

$17.40

Defrost Timer - 120V

This is a 120 volt defrost timer manufactured for refrigerators. The defrost timer manages the automatic defrost systemin the unit. It acts like a clock by switching between activating the cooling cycle and the defrost heater to maintain the set thermostat temperature, preventing the unit from being too warm or cold. The defrost timer may need to be replaced if the fridge will not maintain its temperature or has frost buildup. Depending on the model, it could be located on the rear panel or ceiling of the fresh food compartment. Be sure to disconnect power to the refrigerator before replacing this part.

$43.38

Evaporator Fan Motor with Wire Harness - 115V

This evaporator fan motor is 115V. If you notice that your freezer is noisy or is too warm, you may need to replace the evaporator fan motor. This package comes with the evaporator...

$9.58

Adjustable Leveling Foot - Black

This part could be found underneath a fridge, dryer, or freezer. The original foot may be cracked, broken, or perhaps missing altogether. If you notice the appliance is uneven to the floor or wobbling, it may indicate that the levelling foot needs to be replaced. You will need pliers and a block of wood to perform this task. There will be one adjustable foot found in the package. Lift the dryer and place the wood to keep it propped up. You may need to use the pliers to remove the old foot. Screw the new foot into place using your hand. Once the new leveling foot is in place, lift the appliance and remove the block. Test the machine out to ensure it is now sitting level.

$27.48

Evaporator Fan Blade

This evaporator fan blade is a genuine OEM part that is sourced directly from the manufacturer. The evaporator fan blade circulates air through the refrigerator to control the amou...

$7.42

Single Gasket Retainer Clip

This genuine OEM freezer gasket retainer clip is used on refrigerator freezers, and connects the inner door panel and door gasket to the outer door panel. The gasket is the rubbery strip that seals the space around the edge of the door to keep warm air out of the freezer. When the gasket is not working properly, you may notice an excessive frost buildup or reduced cooling. If the gasket is hanging loosely from the door, the issue could be with the retainer, or the clip fastening the retainer to the gasket, and it should be replaced.

$8.15

Touch Up Paint - White

This is white touch up paint for refrigerators, microwaves, ranges, dryers, and freezers. It is used to cover, or touch up, nicks and scratches on the appliance from wear and tear....

$5.21

SCREW

Sold Individually.

$5.17

RAMP

$5.33

BEARING-HINGE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Temp alarm sounding and food on top shelves partially thawed

  • Customer: Wayne from Forest Hill, MD
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 26 of 26 people found this instruction helpful
After silencing the alarm, it seemed to be running as normal without any unusual noises, but food was starting to thaw from the top shelf on down and condensation was dripping from the roof. We were able to place most of the food in 2 large ice chests and then the rest in the freezer compartments of 2 fridges we have in the house. I then turned down the te... read more

ice was accumulating around door

  • Customer: Cindy from Woodinville, WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 24 of 34 people found this instruction helpful
Removed all of the screws around the door and then removed the old gasket and fitted new gasket into place and replaced the screws read more

Freezer was getting all iced up...

  • Customer: Cheryld from Florence, SC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 15 of 18 people found this instruction helpful
Watched the defrost timer to see that it wasnt moving, looked the part number up on your site and it even had a picture of it so I knew I was getting what I needed, ordered it when it came I took out the screws holding it in place unplugged old one and plugged in the new one, freezer works like new... :)) read more