Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WEF360ESB

WEF360ESB Westinghouse Range - Overview

Get Parts and Repair Help for WEF360ESB

If you know the range repair part you need, you can browse the list of all parts on the WEF360ESB, or you can search by name or part description. You can also find your part by where it is located on the WEF360ESB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for WEF360ESB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$17.15

Bake Element - Push On Terminals - 240V

This bake element is used in electric ovens and ranges. It can be found in the bottom of the appliance. It supplies the heat required for the baking function. If your element is no...

Order within the next 6 hrs and your part ships today!
$23.30

Infinite Burner Switch - 8" - 240V

The infinite burner switch controls the stove top eight-inch surface burner, which is the large surface element. If your surface element is not warming up, the element can be tested to determine whether or not it is defective. If your element is not defective, then it is more than likely that the infinite burner switch is the issue. Before you install the infinite burner switch you will need to unplug your range from the power supply, or shut off the home circuit breaker. The tools you will need to do this repair include a number one square head screwdriver and a pair of needle nose pliers.

Order within the next 6 hrs and your part ships today!
$28.81

Oven Temperature Sensor

The temperature sensor detects the temperature within the oven cavity. If there is a limited amount of heat, it is not heating evenly, or the oven will not start, this might indica...

Order within the next 6 hrs and your part ships today!
$29.34

Infinite Burner Switch - Small Element - 240V

This is a part for your range. This switch controls the stovetop surface burner. If you notice that your stove top is not turning on or is not adjusting to the corresponding desired heat, it is mostly likely due to the burner switch needing to be replaced. You will need a #1 square-head screwdriver and needle-nose pliers. Disconnect the power from the range. You will need to move the range out from the wall to remove the upper back panel to access to this part. This is an OEM genuine part.

Order within the next 6 hrs and your part ships today!
$5.56

Indicator Light Lens

This is a red indicator light lens for an oven that covers the indicator light for the surface element. The indicator light signifies when the element is on and heated. This part i...

Order within the next 6 hrs and your part ships today!
$8.93

Rear Drawer Glide

This rear drawer glide, also known as a storage drawer glide, is used in ranges. This helps hold the front side of the storage drawer and allows the drawer to easily slide in and out of the range. If your glide is damaged or missing, replacing it could solve any difficulty using the drawer. First, remove the storage drawer and locate the rear glide on the side. Next, remove the glide by taking out the screws. Replace new glide by placing tabs into the cut-out. If you are replacing both rear drawer glides, then repeat the same on the other side. Refer to the diagram provided by the manufacturer for further installation instructions and guidance.

Order within the next 6 hrs and your part ships today!
$124.82

Broil Element - 2400W

This part goes inside of your oven at the top.

Order within the next 6 hrs and your part ships today!
$8.93

Front Drawer Glide

The front storage drawer glide on your range is mounted on the side of the cabinet. The purpose of the drawer glide is to support the storage drawer from the front. If your front storage drawer glide is damaged or missing, or your storage drawer does not close properly, you should consider replacing the drawer glide. This product is sold individually. This part is approximately 2 inches in length, and 1 inch in width. The front drawer glide is made of white plastic. Many of our customers have rated this repair as easy. The storage drawer also uses a rear drawer glide, which you can find by searching part 977753.

Order within the next 6 hrs and your part ships today!
$8.35

Anti-Tip Kit

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, ...

Order within the next 6 hrs and your part ships today!
$5.35

Steel Washer

This steel washer is also known as the range washer and is used on your oven door. The measurements for the steel washer are a three quarter inch outer diameter, and a one quarter inch inner diameter. This washer is an OEM part, made of steel, which is sourced directly from the manufacturer. This specific steel washer is used with your range, to secure the inner and outer door together and to secure the oven door handle back in place. Users have ranked this repair as a simple installation that should take you less than fifteen minutes to complete.

Order within the next 6 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven woudn't heat

  • Customer: David from Shawnee, KS
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1113 of 1154 people found this instruction helpful
1. Removed two screws, pulled out the element, voltage tested the element and determined it was an open circuit (bad element).
2. Ordered the part from partselect.com
3. Disconnected element, connected the new one, and screwed it back in. read more

Element cracked in two pieces

  • Customer: Michael from Green Bay, WI
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 714 of 809 people found this instruction helpful
Shut off circuit breaker to stove and collected the tool from the basement. Turned on flashlight. Unscrewed the two hex nuts from the old element/back of the oven. Slid the old element prongs out of the back, exposing the connecting wires. Pulled the connecting wires off of the old element, carefully, so that the connections wouldn't come off of the w... read more

oven did not heat

  • Customer: jack from chambersburg, PA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 415 of 425 people found this instruction helpful
removed screws pulled element out. removed wire from old element replaced with new element.very easy read more