Models > WDT710PAYE3

WDT710PAYE3 Whirlpool Dishwasher - Overview

Get Parts and Repair Help for WDT710PAYE3

If you know the dishwasher repair part you need, you can browse the list of all parts on the WDT710PAYE3, or you can search by name or part description. You can also find your part by where it is located on the WDT710PAYE3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for WDT710PAYE3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$6.78

Mounting Bracket

Sold individually.

$14.45

Rinse Aid Cap

$50.25

Door Gasket with Strike - Black

The gasket provides a seal between the tub and the door. The door strike serves as a mechanical actuator for door switch operation and provides door tension for proper seal.

$3.82

STOP

$54.32

Detergent Dispenser

This part releases the detergent and rinse aid into the dishwasher.

$31.23

Heating Element

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher and also comes with the 2 washers.

$26.20

Track

$3.82

RETAINER

$3.96

Rubber Washer

Sold individually. Used with the heating element.

$50.96

Drain Pump - 120V 60Hz

The pump ejects the water from the unit.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

dishwasher not draining after wash cycle

  • Customer: Andrew from Alexandria VA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 106 of 118 people found this instruction helpful
Caviat: The actual repair is less than 15 minutes, but I spent a lot of time playing with it before I figured out it was that easy and fast. You don't need to remove the dishwasher from the counter to do this. And it will probably help to look at the new part closely so you can understand where the retainer clip is to press it and release the old pump.
... read more

Heater element broken.

  • Customer: Dennis from Sedro Woolley WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Wrench set
  • 55 of 60 people found this instruction helpful
Step 1: Remove the screws in the bottom of the countertop.

Step 2: Remove the screws holding the bottom kickplate.

Step 3: Loosen leveling legs.

Step 4: Pull dishwasher out of hole.

Step 5: Unlplug dishwasher.

Step 6: Disconnect wires from bottom of element in back.

Step 7: Remove plastic nuts... read more

Cap came off and melted

  • Customer: James from Mesquite TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 41 of 41 people found this instruction helpful
Opened door and installed cap. Not much effort. But really got good service from Parts Select. Received order much faster than I had expected. read more