Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WDP632GER0

WDP632GER0 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for WDP632GER0

If you know the dishwasher repair part you need, you can browse the list of all parts on the WDP632GER0, or you can search by name or part description. You can also find your part by where it is located on the WDP632GER0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for WDP632GER0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.03

Single Rack Roller Kit

The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not c...

$3.63

Heating Element Brass Nut

The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the heating element nut. Replacing the nut is an easy job, does not require any specialty tools, and should not take you more than 10 minutes. For our step by step guide, click the video below. The brass nut measures 7 inches in length x 1 inch in width x 5 inches in height, and fits most dishwashers. To see if this part is compatible with your dishwasher, check the list of compatible brands below.

$5.92

Upper Dishrack Roller and Axle Kit

The upper dishrack roller and axel kit comes with two pieces, a wheel and an axle. This kit is made for your dishwasher. Both pieces measure to be roughly one square inch each, the...

$24.82

Door Gasket

This tub gasket, also known as a door seal, is used for dishwashers. This one-piece part provides a water-tight seal between the dishwasher tub and door to prevent water leakage. If you find your dishwasher is leaking or the door will not close, replacing the door seal can solve the issue. The measurement for this door seal is 90 1/4 inches long. Remember to unplug the dishwasher from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for installation instructions.

$6.71

Pan Head Screw

Sold Individually. Order quantity required.

$7.30

Kit - includes 8 Screws & 8 Washers

Use for the upper rack rollers on the upper rack of your dishwasher.

$26.36

Faucet Adapter Coupling

This part connects the drain hose to the sink.

$20.62

Upper Dishrack Track End Cap

Sold individually.

$3.55

WASHER

$5.36

CLAMP

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water leaking under the dishwasher

  • Customer: Dennis from Tryon, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Wrench (Adjustable)
  • 66 of 69 people found this instruction helpful
I looked under and found that 2 brass nuts that secured the heater element through the base housing of the dishwasher has split down each side of the nut and no longer was tight enough to keep water from leaking around either end of the heater element. I powered down the dishwasher at the circuit breaker and then reached under the dishwasher and pulled away... read more

Dishwasher leaked

  • Customer: Darren from Biddeford, ME
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 35 of 40 people found this instruction helpful
First I noticed that the old gasket had disintergrated along the bottom. Next I removed the the gasket being careful to observe how it was installed. There are these notched areas of the gasket that belong in the lower corners. I think the notches are designed to help hold the gasket in place and make the gasket bend around the corner. The gasket made cl... read more

Water leak underneath dishwasher

  • Customer: Richard from New Orleans, LA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench (Adjustable)
  • 9 of 10 people found this instruction helpful
Unplugged dishwasher, removed the 2 wires clipped to the heating element, removed both cracked nuts, replaced with new nuts from PartSelect, clipped on wires, plugged in and did a test cycle. Based upon service quote from Best Buy, I saved myself $125.00 for just the call out, not including parts and labor. read more