WDF730PAYT1 Whirlpool Dishwasher - Instructions

Turned water off. Removed dishwasher from under the counter, replaced hose, reinstalled dishwasher under the counter.

Pulled out the old gasket; carefully inserted the new one in the flange......tested the seal by washing dishes.....then cut off the littler bit of extra gasket (about an inch) Perfect; I should have been a plumber :)

Unscrewed bottom panel of the dishwasher and simply replaced the bad control switch with the new one.

1) Remove (2) dishwasher cabinetry (located on top or side) cap and screws.
2) Pull dishwasher out just far enough to access wheel tub assembly.
3) Remove old, clean area and replace with new.
“Refer to several videos buy goggling part number”.

The gasket had already come loose. We were able to fit the new one in without any trouble. We were trilled that we did not need to pay to have someone out to replace the part.

Pushed in the new gasket and had excess that I cut off. The new gasket leaked because I was short on one side. I had to stretch the gasket to keep it secure and stop leaking.

This doesn't get easier; pull off the old leaky gasket, open package of new gasket, and replace gasket. Done! Good as new and no need for a service call by an expensive repair service.

Removed old gasket...started on the right and side and just eased the new one in the slot around the dishwasher. Just guided it in with a screwdriver and butter knife. I was very pleased with the outcome. I know it would have cost much, much more if I had called an appliance repair company. Thank you!

I removed the old door gasket and cleaned the channel that the gasket sits in. Then I marked the center of the gasket and matched it with the center of the channel. The door latch did get in the way so I had to have another set of hand to get it started. It pretty much went in by hand just by pushing it. There was extra gasket on either side of the bottom of the door. I trimmed to make it fit perfectly. The first time I used the dishwasher it didn't leak. Unfortunately, the second time I did it leaked again. I am going to run it again tomorrow, but does anyone have an idea why it might still be leaking? Thanks

I pulled out the old gasket and pushed the new gasket in with my fingers and a little help from a flathead screwdriver. I went in fairly easily and now it doesn't leak. That simple. Thanks.

Time and heat had deteriorated the door gasket to a point where food was collecting in and around it - I had to remove the old one and clean weekly.

Door Gaskets are easy to replace, just pulled out the old one, cleaned out the slot and inserted the new one - Thanks!

Gently pulled the old gasket out. Cleaned up the area with general purpose cleaner. Placed new gasket in place. Very Easy great do it yourself task no repair call required!! Saved $$$$.

Removed the old seal, which was torn in the lower R corner. Simply applied new seal.

Door gasket was applied with the aid of other users descriptions of the process.

Gasket had a tear in it from utensils in tray moving past the gasket. Pulled off old gasket and pressed new gasket in place. Cut off about 3/4" of excess gasket material with scissors.